Fujitsu Siemens Computers X103 SFF manual Connect the monitor, mouse and keyboard

Page 16

Horizontal operating position with rubber feet

!	The horizontal operating position is only permitted with the rubber feet (due to heat
!	produced on the underside).
	produced on the underside).
		► If necessary, disconnect the cables.
		► If necessary, disconnect the cables.
		► Stick the rubber feet on the base of the
		casing (see illustration).
		► Place the unit on the rubber feet and
		reconnect any cables disconnected
		previously.

Connect the monitor, mouse and keyboard

The ports for the monitor, mouse, and keyboard are on the front and rear of the device.

Keyboard port, purple	USB port, black
Monitor port, blue	DVI interface (optional)
PS/2 mouse port, green
8	VFY-SCED103S, edition 1

Image 16

Contents Edition X103 SFF Are there Page Published by Edition X103 SFF Operating ManualPage Contents Contents Your Edition X103 SFF Notational conventionsPage Safety notes Cleaning the deviceImportant notes Transporting the deviceCE marking Energy saving, disposal and recyclingCE marking for devices without radio component Steps for initial setup Preparing for useUnpacking and checking the delivery External devicesSetting up the device Vertical operating position Connect the monitor, mouse and keyboard Horizontal operating position with rubber feetConnecting the mouse Connecting the monitorConnecting a keyboard Connecting the device to the mains voltage Initial switch-on Software will be installedConnecting external devices Switching on monitor and deviceInstalling the software Connecting cablesDisconnecting cables Ports provided by the deviceConnecting external devices to the parallel or serial port Connecting external devices to the USB portsPort settings Device driversPage Switching off the device Switching the device onOperation Indicators provided by the device Drive indicator, e.g. DVDFloppy disk indicator Hard disk indicatorON/OFF switch optional KeyboardImportant keys and key combinations Enter keyWarm boot Menu keyShift key Alt Gr e.g. German keyboardSettings in Bios Setup Working with floppy disksPage Troubleshooting and tips Installing new softwareMains voltage supply is faulty Internal power supply overloadedDevice cannot be switched off with the ON/OFF switch Screen stays blankNo mouse pointer displayed on the screen Floppy disk cannot be read or writtenWrong monitor has been set under Window XP Wrong RAM modules have been insertedError messages on the screen Restoring the hard disk contentsTime and/or date is not correct TipsSystem expansions Information about boardsOpening the casing Opening and closing the casingClosing the casing Installing a board Assembling and dismantling low-profile unitsRemoving the holding plate Removing a boardInserting and removing the drive cage Removing the drive cageRemoving the cross-piece Removing the front panelDisconnecting cables Removing the drive cage Installing the drive cageAttaching the drive cage System expansions Installing the cross-piece Installing and removing drivesIDE drives and serial ATA drives Removing and installing accessible drives Installing and removing the hard diskSystem expansions Replacing lithium battery Extensions to the mainboardMaking changes on mainboard Upgrading main memoryFollowing changes Page Technical data DimensionsWeight Electrical dataPage Cable IndexData Index Scsi