Chapter 2 Installing and Booting the Cisco SFS 3012R Server Switch
Booting the Cisco SFS 3012R Server Switch and Configuring Basic Connectivity
Assigning a Static IP Address
To configure basic Ethernet connectivity with a static IP address, perform the following steps:
Step 1 Attach an Ethernet cable (not provided) from the management port to the Ethernet router or switch. Step 2 Enter the enable command.
Step 3 Enter the configure command.
Step 4 Enter the interface mgmt-ethernet command.
Step 5 Enter the IP address of the management port followed by the net mask, as shown in this example:
Step 6 Set the default gateway of the management port, as shown in this example:
Step 7 Enable the management port with the no shutdown command.
Step 8 Save the configuration to preserve it between reboots.
You can now establish a Telent session to your Cisco SFS 3012R Server Switch or enter the IP address of your Cisco SFS 3012R Server Switch in a web browser to launch Chassis Manager.
Obtaining an IP Address with DHCP
To obtain an IP address dynamically, follow these steps.
Step 1 Attach an Ethernet cable (not provided) from the management port to the Ethernet router or switch. Step 2 Enter the enable command.
Step 3 Enter the configure command.
Cisco SFS 3012R Multifabric Server Switch Hardware Installation Guide
|
| ||
|
|