Chapter 3 Installing and Removing Server Switch Field Replaceable Units (FRUs)
Removing a Power Supply Module
Removing a Power Supply Module
Caution Never place your hand inside an empty module bay or anywhere inside the Cisco SFS 3012R Server Switch.
To remove the power supply, perform the following steps:
Step 1 Ground yourself using an approved ground wrist strap.
Step 2 Remove the power cord from the power supply.
Step 3 Disengage the power supply by pulling it toward you.
Step 4 Slide the power supply out of the chassis.
Step 5 Either replace the power supply immediately or fasten a blanking panel to the empty chassis bay to ensure appropriate cooling.
Note The blanking panel is a flat sheet of metal with the same dimensions as the power module faceplate.
Caution Never operate the device without a blanking panel or power supply module in place because the device might overheat.
Installing a Blower Module
To insert a blower module, perform the following steps:
Step 1 Ground yourself using an approved ground wrist strap.
Step 2 Remove the blower module from any packaging.
Cisco SFS 3012R Multifabric Server Switch Hardware Installation Guide
|
| ||
|
|