Cisco Systems 7507 quick start Install the DC-Input Power Supply, On terminal block cover

Page 15

Install the Hardware

Install the DC-Input Power Supply

		Captive installation screws
		on terminal block cover
	R TO BE FULLY ENGAGED	DO NOT SHIP WITH POWER SUPPLY	FASTENER TO BE FULLY ENGAGED
	R TO BE FULLY ENGAGED	INSTALLED	FASTENER TO BE FULLY ENGAGED
	OPERATING POWER SUPPLY	INSTALLED	BEFORE OPERATING POWER SUPPLY
	OPERATING POWER SUPPLY		BEFORE OPERATING POWER SUPPLY
		OUT
		FAIL
		INPUT
		POWER

	INPUT VOLTAGE : 40-72 V=
	INPUT CURRENT : 24-13A
allation screws	I
allation screws
l block cover
	O
B	NO SERVICEABLE COMPONENTS
	NO SERVICEABLE COMPONENTS

13

Image 15

Contents Quick Start Guide Page Packing List Install the HardwareFor rack-mounting optional Prepare to Install the RouterInstall the Router Grommets Rack-Mount the Router OptionalMount Brackets to the Rack Posts Step Secure the SpacersAttach the Chassis Ears Mount the Chassis in the Rack Remove the Chassis Foot Install Interface Processors, Fillers, VIPs, or RSPs Install Power Supplies in the Router Page On terminal block cover Install the DC-Input Power SupplyPage Connect the RSP Connect the Console and the Auxiliary Y-Cables Start and Conﬁgure the System Start a Basic Conﬁguration Perform a Basic Conﬁguration Using Setup At the # prompt, enter the copy Conﬁgure an Ethernet Interface Hostname# copy running-config startup-config Perform a Basic Conﬁguration Using Conﬁguration Mode Flash Memory Cards Install Field Replaceable Units FRUsPage Copy Files to Flash Memory Format a Flash Memory CardEnable Booting from Flash Memory Make a Flash Memory Card Image BootablePrepare to Remove and Install an RSP Stop Check the RSP Installation Check the Interface Processor or VIP Installation Copy the Conﬁguration File for an RSP Router# copy startup-config tftp Writing Router-confg Retrieve the Conﬁguration File for RSPs Systemrunning-conﬁg Nvramstartup-conﬁg command Remove and Install Port Adapters Page Remove and Replace the Power Supply H2530 Headquarters