Cisco Systems 7507 manual

Start and Conﬁgure the System

Perform a Basic Conﬁguration Using Conﬁguration Mode

At the reboot, the following example appears:

Any interface listed with OK? value "NO" does not have a valid configuration.

Interface IP-Address OK? Method Status Protocol

Ethernet0/0 unassigned NO not set down down Serial1/0 unassigned NO not set down down

Step 1 Enter the conﬁgure terminal command at

the enable prompt to enter conﬁguration

mode from the terminal, as follows:

Router# configure terminal

Enter configuration commands, one per line. End with CNTL/Z.

Router(config)#

Step 2 Enter the interface type slot/port

command at the enable prompt to enter

interface conﬁguration mode, as follows:

Router(config)# interface serial slot/port Router(config-if)#

Step 3 Press Ctrl-Zto exit conﬁguration mode.

Step 4 At the # prompt, enter the copy

running-conﬁg startup-conﬁg command

to save the conﬁguration to NVRAM as

follows:

Hostname# copy running-config startup-config

Your Cisco 7507 router is now minimally conﬁgured and ready to use. If you want to modify the parameters after the initial conﬁguration, use the setup command. To perform more complex conﬁgurations, use the conﬁgure command. For more information on additional interface conﬁguration and information on more speciﬁc system conﬁgurations, refer to the Cisco 7500 Series Installation and Conﬁguration Guide.