Cisco Systems 7507 quick start Writing Router-confg

34

Install Field Replaceable Units (FRUs)

Step 7 Enter the name of the configuration file. The default is to use the name of the router with the suffix -confg.Press Return to accept the default filename, or enter a different name for the file, then press Return. In the following example, the default is accepted:

Name of configuration file to write [Router-confg]?

Write file Router-confg on host 1.1.1.1? [confirm]

Writing Router-confg .....

Step 8 The system displays the instructions you entered for confirmation. If the instructions are not correct, enter n (no), and then press Return to cancel the process. To accept the instructions, press Return, or press y and then press Return. In the following example, the default is accepted:

Write file Router-confg on host 1.1.1.1? [confirm]

Writing Router-confg: !!!! [ok]

The system displays a series of exclamation points

(! ! !) or periods (. . .) during the copy process. The !!!! and [ok] indicate that the operation was successful. A series of periods (...) and [timed out] or [failed] indicates a failure of the process.

If the display indicates that the process was successful, the copy process is complete. The configuration is stored on the remote file server.

If the display indicates that the process failed, the configuration was not saved (see the following example):

Writing Router-confg .....

Repeat the preceding steps, or select a different remote file server and repeat the preceding steps.

After you upload the configuration file, continue with the “Remove and Install an Interface Processor, Filler, VIP, or RSP” section on page 29 to install the RSP. If you are unable to copy the configuration to a remote host successfully, contact your network administrator or contact Cisco technical assistance.