Install Field Replaceable Units (FRUs)
Retrieve the Configuration File for RSPs
Retrieve the saved configuration and copy it to NVRAM by accessing the router through a console terminal, or from a remote terminal.
Step 1 Enter the enable command at the EXEC prompt (>), and then enter a
Router> enable
Password:
Router#
Note The router runs from the default configuration in NVRAM until the previous configuration is retrieved. Passwords configured on the previous system are not valid until they are retrieved.
Step 2 Enter the ping command followed by the name or IP address of the remote server, and then press Return to check the connection between the router and the remote host.
Step 3 Enter the copy tftp
Router# copy tftp
Step 4 Enter the IP address or name of the remote host (the remote TFTP server to which you originally saved the configuration file).
Address of remote host [255.255.255.255]?
10.1.1.1
Step 5 Enter the name of the configuration file. The default is to use the name of the router with the suffix
you copied the configuration, enter the filename; otherwise, press Return to accept the default.
Name of configuration file
Step 6 Before the system reloads the new configuration file in NVRAM, it displays the instructions you entered for confirmation. If the instructions are not correct, enter n (no), and then press Return to cancel the process. To accept the instructions, press Return, or press y and then press Return. Output similar to the
following appears:
Configure using
Loading
Warning: distilled config is not generated [OK]
35