Cisco Systems 7507 quick start Secure the Spacers, Step

6

Install the Hardware

Secure the Spacers

A

C

B

53380

Step 1 Loosen the 10-32 x 5/8-inch LG Phillips	Step 4	Repeat Step 1 through Step 3 to fasten the
pan-head screw at the end of the ledge of		remaining spanner bar to its anchor screw.
the right-side bracket. This screw is the		(See C.)
anchor for the spanner bar.	Step 5	Push the brackets as far apart as possible
Step 2 Remove the tape that secures the spanner		before tightening the screws.
bar on the left bracket, and swing the bar	Step 6	Use a Number 2 Phillips screwdriver to
down (see A) over the anchor screw on the
		tighten the six pan-head screws that
opposite bracket.
		secure the brackets to the rack-mounting
Step 3 If the spanner bar does not reach the		posts, and the two anchor screws that
opposite bracket, loosen the pan-head		secure the spanner bars. (See B.)
screws to allow more play between the	Step 7	Adjust the brackets if the distance
brackets.
		between them is less than 17.5 inches
		(44.45 cm).