Cisco Systems 7507 quick start Systemrunning-config Nvramstartup-config command

Install Field Replaceable Units (FRUs)

The console display indicates whether or not the operation was successful. A series of exclamation points (!!!!) and [OK] (as shown in the preceding example) indicates that the operation was successful. A series of periods (.

. .) and [timed out] or [failed] indicates a failure due to a network fault or an incorrect server name, address, or filename). The following is an example of a failed attempt to boot from a remote server:

Booting Router-confg [timed out]

If the display indicates that the process was successful, as shown in Step 6, proceed to the next step.

If the display indicates that the process failed, verify the name or IP address of the remote server and the filename, and repeat the preceding steps. If the process fails again, contact your network administrator.

36

Step 7 Enter the show startup-configcommand to confirm that the configuration file was retrieved correctly. Look at the first line for the configuration file size. Compare it with the file you retrieved from the TFTP server to confirm that it is correct. Following is an example:

Router# show startup-config

Using 1186 out of 126968 bytes

!

version 12.0(9)S hostname Router

!

Router#

system, enter the copy

system:running-config

nvram:startup-config command:

Router# copy system:running-config nvram:startup-config

Router#

%SYS-5-CONFIG_I: Configured from memory by console

Router#

This completes the process for retrieving the

configuration file for the RSP.

Step 8 To ensure that the startup configuration file stored in NVRAM is the default running configuration file used by the