Cisco Systems 7507 quick start Hostname# copy running-config startup-config

Page 24

22

Step 4 At the # prompt, enter the copy running-conﬁgstartup-conﬁgcommand to save the conﬁguration to

NVRAM as follows:

Hostname# copy running-config startup-config

Your Cisco 7507 router is now minimally conﬁgured and ready to use. If you want to modify the parameters after the initial conﬁguration, use the setup command. To perform more complex conﬁgurations, use the conﬁgure command. For more information on additional interface conﬁguration and information on more speciﬁc system conﬁgurations, refer to the Cisco 7500 Series Installation and Conﬁguration Guide.

Image 24

Contents Quick Start Guide Page Install the Hardware Packing ListPrepare to Install the Router For rack-mounting optionalInstall the Router Rack-Mount the Router Optional GrommetsMount Brackets to the Rack Posts Secure the Spacers StepAttach the Chassis Ears Mount the Chassis in the Rack Remove the Chassis Foot Install Interface Processors, Fillers, VIPs, or RSPs Install Power Supplies in the Router Page Install the DC-Input Power Supply On terminal block coverPage Connect the RSP Connect the Console and the Auxiliary Y-Cables Start and Conﬁgure the System Start a Basic Conﬁguration Perform a Basic Conﬁguration Using Setup At the # prompt, enter the copy Conﬁgure an Ethernet Interface Hostname# copy running-config startup-config Perform a Basic Conﬁguration Using Conﬁguration Mode Install Field Replaceable Units FRUs Flash Memory CardsPage Format a Flash Memory Card Copy Files to Flash MemoryMake a Flash Memory Card Image Bootable Enable Booting from Flash MemoryPrepare to Remove and Install an RSP Stop Check the RSP Installation Check the Interface Processor or VIP Installation Copy the Conﬁguration File for an RSP Router# copy startup-config tftp Writing Router-confg Retrieve the Conﬁguration File for RSPs Systemrunning-conﬁg Nvramstartup-conﬁg command Remove and Install Port Adapters Page Remove and Replace the Power Supply H2530 Headquarters