32
Install Field Replaceable Units (FRUs)
Copy the Configuration File for an RSP
Refer to the appropriate Cisco IOS software documentation for the configuration options available, and for specific configuration instructions, as needed.
Before you copy (save) the running configuration to a TFTP file server, ensure the following:
•You have a connection to the router either with a console terminal connected to the RSP console port or remotely through a Telnet session.
•The router is connected to a network supporting a file server (remote host).
•The remote host supports the TFTP application.
•You have the interface processor address or name of the remote host available.
Step 1 Enter the enable command at the EXEC prompt (>), and then enter a
Router> enable
Password:
Router#
Step 2
Step 3
Step 4
Note Before you can save a file to a TFTP server, a file must first exist on the TFTP server. Create this file. Ensure that the filename matches the filename you will copy from the router. Also, ensure that the server permissions are set so the router can copy to this file.
Step 5 Enter the copy
Router# copy
Remote host []?