Cisco Systems 7507 quick start At the # prompt, enter the copy

Page 22

20

Step 7 Enter yes or press Return to configure IP, and then select an interior routing protocol for IP, if you are

using IP routing:

Configure IP? [yes]: yes

Configure IGRP routing? [yes]: yes

Your IGRP autonomous system number [1]: 15

Step 8 At the # prompt, enter the copy

running-config startup-config command

to save the configuration to NVRAM as

follows:

Hostname# copy running-config startup-config

Note Consult your network administrator to

obtain network addresses and subnet mask

information.

Image 22
Contents Quick Start Guide Page Install the Hardware Packing ListPrepare to Install the Router For rack-mounting optionalInstall the Router Rack-Mount the Router Optional GrommetsMount Brackets to the Rack Posts Secure the Spacers StepAttach the Chassis Ears Mount the Chassis in the Rack Remove the Chassis Foot Install Interface Processors, Fillers, VIPs, or RSPs Install Power Supplies in the Router Page Install the DC-Input Power Supply On terminal block coverPage Connect the RSP Connect the Console and the Auxiliary Y-Cables Start and Configure the System Start a Basic Configuration Perform a Basic Configuration Using Setup At the # prompt, enter the copy Configure an Ethernet Interface Hostname# copy running-config startup-config Perform a Basic Configuration Using Configuration Mode Install Field Replaceable Units FRUs Flash Memory CardsPage Format a Flash Memory Card Copy Files to Flash MemoryMake a Flash Memory Card Image Bootable Enable Booting from Flash MemoryPrepare to Remove and Install an RSP Stop Check the RSP Installation Check the Interface Processor or VIP Installation Copy the Configuration File for an RSP Router# copy startup-config tftp Writing Router-confg Retrieve the Configuration File for RSPs Systemrunning-config Nvramstartup-config command Remove and Install Port Adapters Page Remove and Replace the Power Supply H2530 Headquarters