Cisco Systems 7507 quick start Mount Brackets to the Rack Posts

Page 7

Install the Hardware

Mount Brackets to the Rack Posts

Rack post

Flange

53382

Note The distance between the inner edges of the

Step 4 Secure the top of the bracket to the rack

left and right rack-mounting posts must be at least

with two pan-head screws. Finger-tighten

17.72 inches (45.088 cm), and the distance between

the screws.

the holes in the mounting posts must be 18.31 inches

Step 5 Push the brackets as far apart as possible

(46.5 cm) (+ .063 inches or .16 cm).

before using a Number 2 Phillips

 

Step 1 Place the bracket on the inner side of the

screwdriver to tighten the screws.

rack post, with the flanged front edge of

Step 6 Adjust the brackets if the distance

the bracket in front of the rack post.

between them is less than 17.5 inches

 

Step 2 Align the mounting holes in the bracket

(45.45 cm).

with those in the rack post.

Step 7 Repeat Step 3 through Step 6 for the

 

Step 3 Support the bracket with one hand, and

remaining bracket. Use a level or tape

use the other hand to insert a 10-32 x

measure to ensure that the two brackets

5/8-inch LG Phillips pan-head screw

are level in the rack.

through the bottom mounting hole on the

 

front of the bracket and into the rack post.

 

5

Image 7
Contents Quick Start Guide Page Packing List Install the HardwareFor rack-mounting optional Prepare to Install the RouterInstall the Router Grommets Rack-Mount the Router OptionalMount Brackets to the Rack Posts Step Secure the SpacersAttach the Chassis Ears Mount the Chassis in the Rack Remove the Chassis Foot Install Interface Processors, Fillers, VIPs, or RSPs Install Power Supplies in the Router Page On terminal block cover Install the DC-Input Power SupplyPage Connect the RSP Connect the Console and the Auxiliary Y-Cables Start and Configure the System Start a Basic Configuration Perform a Basic Configuration Using Setup At the # prompt, enter the copy Configure an Ethernet Interface Hostname# copy running-config startup-config Perform a Basic Configuration Using Configuration Mode Flash Memory Cards Install Field Replaceable Units FRUsPage Copy Files to Flash Memory Format a Flash Memory CardEnable Booting from Flash Memory Make a Flash Memory Card Image BootablePrepare to Remove and Install an RSP Stop Check the RSP Installation Check the Interface Processor or VIP Installation Copy the Configuration File for an RSP Router# copy startup-config tftp Writing Router-confg Retrieve the Configuration File for RSPs Systemrunning-config Nvramstartup-config command Remove and Install Port Adapters Page Remove and Replace the Power Supply H2530 Headquarters