Cisco Systems uBR7200 Series manual Show Cable Hop Parameter Descriptions

Chapter 4 Troubleshooting the System

Managing Cable Modems on the HFC Network

Table 4-14 Show Cable Hop Parameter Descriptions

Field		Description
Upstream Port		The upstream port for this information line
Port Status		Show “down” if frequency is unassigned, “admindown” if the port is
		shutdown, or the center frequency of the channel if the port is up
Poll Rate		The rate station maintenance polls are generated (msec)
Missed Poll Count		The number of missing polls
Min Poll Sample		The number of polls in the sample
Missed Poll Pcnt		The ratio of missing polls to the number of polls expressed as a percentage
Hop Thres Pcnt		The level that the missed poll percentage must exceed to trigger a frequency
		hop expressed as a percentage
Hop Period		The maximum rate which frequency hopping will occur (seconds)
Corr FEC Errors		The number of correctable FEC errors on this upstream port
Uncorr FEC Errors		The number of uncorrectable FEC errors on this upstream port
noisy1#show	cable hop
Upstream	Port	Poll Missed		Min	Missed Hop		Hop	Corr	Uncorr
Port	Status	Rate Poll		Poll	Poll	Thres	Period	FEC	FEC
		(ms) Count		Sample Pcnt		Pcnt	(sec)	Errors	Errors
Cable3/0/U0	down	1000	* * * frequency not set				* * * 0		0
Cable3/0/U1	admindown	1000	* * * interface is down				* * * 0		0
Cable3/0/U2	admindown	1000	* * * interface is down				* * * 0		0
Cable3/0/U3	admindown	1000	* * * interface is down				* * * 0		0
Cable3/0/U4	admindown	1000	* * * interface is down				* * * 0		0
Cable3/0/U5	admindown	1000	* * * interface is down				* * * 0		0
Cable4/0/U0	10.800 Mhz 1000		0	0	-----	100%	300	0	0
Cable6/0/U0	down	1000	* * *	frequency not set			* * * 0		0

Using Cisco IOS Release 12.0(5)T1 or higher headend images, you can use the following command to obtain specific upstream interface information:

show cable hop cable-if[upstream <portnum>]

Table 4-15 Upstream Port Parameter Descriptions

	Field		Description
	Upstream Port		The upstream port for this information line
	Port Status		Show “down” if frequency is unassigned, “admindown” if the port is
			shutdown, or the center frequency of the channel if the port is up
	Poll Rate		The rate station maintenance polls are generated (msec)
	Missed Poll Count		The number of missing polls
	Min Poll Sample		The number of polls in the sample
	Missed Poll Pcnt		The ratio of missing polls to the number of polls expressed as a percentage
	Hop Thres Pcnt		The level that the missed poll percentage must exceed to trigger a frequency
			hop expressed as a percentage
	Hop Period		The maximum rate at which frequency hopping will occur (seconds)
		Cisco uBR7200 Series Universal Broadband Router Software Configuration Guide
78-5897-01				4-15