Cisco Systems OL-4858-07 manual Command Reference Command Details

Chapter 6 Command Reference

Command Details

Field descriptions for the output of this command are listed below:

Active	Processor is operational and remote console/logging is active.
Online	Processor is operational but remote console/logging is not active.
	Note This state commonly occurs when a processor is not enabled by the
	application running on the MWAM.
Inactive	Processor is rest or resetting, and remote console/logging is inactive.
Proving	The remote console connection is testing the IP path between the Supervisor
	and MWAM processor before moving to the ACTIVE state. If there is a
	configuration problem or VLAN mismatch, the connection may stay in Proving
	state until the configuration issue is resolved.
ttynum	Line number of the user with an active command on the processor. A value of
	-1 indicates no user.
Logging Level	Indicates the maximum severity level at which the Supervisor displays logger
	messages from an MWAM.
timeouts	Number of occurrences of remote command execution time-out.
logevents	Number of logging events.
sequence errors	Protocol sequence errors caused by overrun or time-out.
reset count	Number of times the connection reset because of connection time-out or
	MWAM processor reload.
KPA_missed	Number of keepalives missed.
send seq	Sequence number of remote commands sent.
tty recv seq	Sequence number of remote command response messages received from the
	MWAM processor.
log recv seq	Sequence number of remote logging messages received from the MWAM
	processor.
Current queue count	Number of messages received at the Supervisor and queued to be processed
	(logged/displayed).
IP addr	IP address of the MWAM processor.
	Note Typically, this is an internal address, but it can be a defined address,
	such as the one shown in processor 6 (06/6) in the example. Use the
	logging main-cpucommand on the MWAM processor to define a
	different IP address, if required.

Multiprocessor WAN Application Module User Guide

6-18 OL-4858-07