Cisco Systems OL-4858-07 Execute-on, Defaults Command Modes Command History Usage Guidelines

Chapter 6 Command Reference

Command Details

execute-on

To initiate a remote command request on an MWAM processor from the Supervisor console, use the execute-oncommand in privileged EXEC mode.

execute-on{slot_number all} {processor_number all} command [subcommand]

Syntax Description	slot_number	Specifies the slot that the module is plugged into.
	all	Specifies all the MWAMs in the chassis.1
	processor_number	Specifies the processor number within the MWAM.
	all	Specifies all the processors in the MWAM.1
	command	Specifies the command to execute on the MWAM processor. The following
		commands are supported:
		•	debug
		•	dir
		•	show
		•	systat
		•	undebug
		• ping ip_addr
		•	log {show systat dir}
		The commands of the PC are also supported (see Processor Control
		Commands).
	subcommand	(Optional) Additional parameters to be included with the command and
		executed by the remote processor.

Note No Help is available for the parameter portion of the command.

1.When using the all option, the command is executed on all active processors but is not executed on processors that are inactive. The processor state can be shown using the show logging command.

Defaults

Command Modes

Command History

Usage Guidelines

There are no default behavior or values.

Privileged EXEC.

Release	Modification
12.2(14)ZA4	This command was introduced.
12.3(5a)B	Added remote console support for PC commands.

The remote console and logging feature must be configured to use the execute-oncommand. See Configuring Remote Console and Logging.

When using the all options, the designated command is executed on all active processors. Inactive processors are ignored. Use the show logging command to determine if the processor is active.

Multiprocessor WAN Application Module User Guide

OL-4858-07 6-13