Cisco Systems OL-4858-07 manual Mwam config-mode, Syntax Description, Local mode

Chapter 6 Command Reference

Command Details

mwam config-mode

To set the MWAM configuration file storage mode, use the mwam config-modecommand in privileged EXEC mode from the MWAM console.

mwam config-mode {local supervisor}

Syntax Description	mwam config-mode	Sets the MWAM configuration file storage mode.
	local	Stores configuration files locally in NVRAM of the MWAM processor.
	supervisor	Stores configuration files in the Supervisor bootflash.

Defaults	Default setting depends on the contents of NVRAM. If NVRAM contains no startup-configfile, the
	default setting is Supervisor mode. If the NVRAM contains a startup-configfile, the default setting is
	local mode.

Command Modes

Command History

Privileged EXEC

ReleaseModification

12.3(1a)BW This command was introduced.

Usage Guidelines	Use this command when you want to set the MWAM configuration file storage mode. You must first
	enable MWAM access to the Supervisor bootflash with the mwam bootflash access command from the
	Supervisor console.
Caution	If you are operating in the Supervisor mode in a chassis that does not have redundant Supervisor
	modules, back up both the startup-configfile of the Supervisor module and all SLOT*PC*.cfg files on
	the bootflash device. Failure to take this precaution could result in the loss of all MWAM configurations,
	along with the Supervisor configuration.
	The following examples illustrate the mwam config-modecommand:
Examples
	mwam-6-4#mwam config-mode local
	Building configuration...
	[OK]
	Successfully changed mode: mwam config-mode local
	mwam-6-4#mwam config-mode supervisor
	Writing bootflash:SLOT6PC4.cfg
	Config uploaded to supervisor in slot 1
	Successfully changed mode: mwam config-mode supervisor

Multiprocessor WAN Application Module User Guide

6-30 OL-4858-07