Cisco Systems OL-4858-07 manual Mwam module vlan-based, Module Port Vlan-based

Chapter 6 Command Reference

Command Details

mwam module vlan-based

To assign MWAM traffic to a VLAN QoS policy, use the mwam module vlan-basedcommand in global configuration mode. To remove this configuration, use the no form of the command.

mwam module slot_number port port_number vlan-based

no mwam module slot_number port port_number vlan-based

Syntax Description	slot_number	Specifies the slot that the module is plugged into.
	port_number	Specifies one of three switch fabric interface ports (1-3) that connect the
		Supervisor module to the MWAM.
Defaults	There are no default behavior or values.

Command Modes

Command History

Global configuration.

ReleaseModification

12.2(14)ZA7 This command was introduced.

Usage Guidelines Use this command to assign MWAM traffic to a VLAN QoS policy.

See Figure 1-1and Table 1-1to determine which port corresponds to each processor.

Examples	The following example illustrates the mwam module vlan-basedcommand:
	Sup-7606(config)# mwam		module 5		port 1		vlan-based
	Sup-7606(config)#	mwam	module	5	port	2	vlan-based
	Sup-7606(config)#	mwam	module	5	port	3	vlan-based

Multiprocessor WAN Application Module User Guide

6-4 OL-4858-07