Cisco Systems OL-4858-07 manual Show mwam module, Sup-7606#sho mwam mod 7 port 1 state

Chapter 6 Command Reference

Command Details

show mwam module

To display connectivity information about the individual processors on the MWAM, use the show mwam module command in privileged EXEC mode.

show mwam module slot_number port port_number {state traffic}

Syntax Description	slot_number	Displays the slot that the module is plugged into.
	port port_number	Displays the actual port number (1-3) used to connect to a processor
		complex within an MWAM (Figure 1-1).
	state	Displays the interface status.
	traffic	Displays the interface statistics.
Defaults	There are no default behavior or values.

Command Modes

Command History

EXEC mode.

ReleaseModification

12.2(9)ZA This command was introduced.

Examples	The following example illustrates the show mwam module command:
	Sup-7606#sho mwam mod 7 port 1 state
	Mwam module 7 data-port 1:
	Switchport: Enabled
	Administrative Mode: trunk
	Operational Mode: trunk
	Administrative Trunking Encapsulation: dot1q
	Operational Trunking Encapsulation: dot1q
	Negotiation of Trunking: Off
	Access Mode VLAN: 1 (default)
	Trunking Native Mode VLAN: 1 (default)
	Trunking VLANs Enabled: 1-999
	Pruning VLANs Enabled: 2-1001
	Vlans allowed on trunk:1-999
	Vlans allowed and active in management domain:1,3,11-12,17,60
	Vlans in spanning tree forwarding state and not pruned:
	1,3,11-12,17,60
	Allowed-vlan : 1-999
	Sup-7606#sho mwam mod 7 port 1 traffic
	Specified interface is up line protocol is up

Hardware is C6k 1000Mb 802.3, address is 0010.7b00.0cb0 (bia 0010.7b00.0cb0) MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,

reliability 255/255, txload 1/255, rxload 1/255

	Encapsulation ARPA, loopback not set
	Keepalive set (10 sec)
	Full-duplex, 1000Mb/s
	Last input never, output never, output hang never
	Multiprocessor WAN Application Module User Guide
OL-4858-07		6-7