Cisco Systems OL-4858-07 manual Sup-7606#sho mwam mod 7 port 3 state

Page 8

Chapter 6 Command Reference

Command Details

Last clearing of "show interface" counters never

Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 67

Queueing strategy: fifo Output queue :0/40 (size/max)

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 1000 bits/sec, 3 packets/sec

0 packets input, 0 bytes, 0 no buffer

Received 0 broadcasts, 0 runts, 0 giants, 0 throttles 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored 0 input packets with dribble condition detected 46504312 packets output, 2501255885 bytes, 0 underruns 0 output errors, 0 collisions, 10 interface resets

0 babbles, 0 late collision, 0 deferred

0 lost carrier, 0 no carrier

0 output buffer failures, 0 output buffers swapped out

Sup-7606#sho mwam mod 7 port 2 state Mwam module 7 data-port 2: Switchport: Enabled Administrative Mode: trunk Operational Mode: trunk

Administrative Trunking Encapsulation: dot1q

Operational Trunking Encapsulation: dot1q

Negotiation of Trunking: Off

Access Mode VLAN: 1 (default)

Trunking Native Mode VLAN: 1 (default)

Trunking VLANs Enabled: 1-999

Pruning VLANs Enabled: 2-1001 Vlans allowed on trunk:1-999

Vlans allowed and active in management domain:1,3,11-12,17,60 Vlans in spanning tree forwarding state and not pruned:

1,3,11-12,17,60 Allowed-vlan : 1-999

Sup-7606#sho mwam mod 7 port 2 traffic Specified interface is up line protocol is up

Hardware is C6k 1000Mb 802.3, address is 0010.7b00.0cb1 (bia 0010.7b00.0cb1) MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,

reliability 255/255, txload 1/255, rxload 1/255 Encapsulation ARPA, loopback not set

Keepalive set (10 sec) Full-duplex, 1000Mb/s

Last input 00:00:09, output never, output hang never Last clearing of "show interface" counters never

Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 68

Queueing strategy: fifo Output queue :0/40 (size/max)

5 minute input rate 1000 bits/sec, 1 packets/sec

5 minute output rate 1000 bits/sec, 2 packets/sec

24922473 packets input, 430882532 bytes, 0 no buffer Received 93145 broadcasts, 0 runts, 0 giants, 0 throttles 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

0 input packets with dribble condition detected

26261319 packets output, 4263983434 bytes, 0 underruns

0 output errors, 0 collisions, 10 interface resets

0 babbles, 0 late collision, 0 deferred

0 lost carrier, 0 no carrier

0 output buffer failures, 0 output buffers swapped out

Sup-7606#sho mwam mod 7 port 3 state

Mwam module 7 data-port 3:

Switchport: Enabled

Administrative Mode: trunk

Operational Mode: trunk

Multiprocessor WAN Application Module User Guide

6-8

OL-4858-07

 

 

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Command Reference Following commands are available at the Supervisor consoleProcessor Control Commands Following commands are available at the Mwam consoleCommand Modes Command History Global configurationMwam module allowed-vlan ReleaseModificationMwam Module Port Vlan-based Mwam module vlan-basedModule Port Vlan-based Exec mode 12.29ZA This command was introducedSession slot Usage Guidelines2003 Following example illustrates the show mwam module command Show mwam moduleSup-7606#sho mwam mod 7 port 1 state Sup-7606#sho mwam mod 7 port 1 trafficSup-7606#sho mwam mod 7 port 3 state Multiprocessor WAN Application Module User Guide OL-4858-07 Mwam bootflash access Defaults Command Modes Command HistoryConfiguration Sup-7606config#mwam bootflash accessSyntax Description Defaults There are no default behavior or valuesOn the MWAM, you have configured processor 2 as follows Logging listen mwamMwam Processor Base UDP Port 40-10000Additional UDP Port 40-10002 40-10003 40-10004 40-10005 40-10006Defaults Command Modes Command History Usage Guidelines There are no default behavior or values Privileged ExecExecute-on Release ModificationSlot Connection, use the show line linenumber commandSup-7600#execute-on 5 2 log show running-config Sup-7600config#mwam module all cpu all logging error Mwam module cpu loggingSup-7600config#mwam module 5 cpu 2 logging debug Show logging Release ModificationCommand Reference Command Details Clear logging slot Router# clear logging slot 6 countsShow processor Counter DescriptionRoot@mwam-9# Shows the upgrade log Following examples illustrate the show log commandShow log Shows the Mwam and process restart logReload Recover-ios Root@mwam-9#recover-iosNormal-ios 12.9ZA This command was introducedFollowing example illustrates the normal-ioscommand Show images Use this command to list the image names on the MwamFollowing example illustrates the show images command Restore Following example illustrates the restore commandReporting a problem Following example illustrates the show tech-supportcommandShow tech-support Root@mwam-4#show tech-supportShow version Mwam config-mode Local mode12.31aBW This command was introduced Syntax DescriptionShow mwam config-mode Show Mwam Config-modeLogging main-cpu Mwam-6-4config#logging main-cpu Mwam-6-4config#logging main-cpu 10000 debugFollowing examples illustrate the show mwam command Show mwam0x214800000x214FFFFF 0x0014800000x0014FFFFF OL-4858-07
Top Page Image Contents