Required Operations
This is done using Network Tools, or MIB Navigator, depending on the host platform. Refer to the host platform user’s guide for information on how to navigate through the Local Management screens in order to access Network Tools.
Follow these steps to configure the
1.Once in Network Tools, choose between T1 and DDS setup using this command:
t1dds <SLOT> <T1/DDS>
where SLOT is either 1 for slot one of the host platform for the WPIM, or 2 for slot two, and T1/DDS is either 1 for DDS service, or 2 for T1 service.
2.Assuming the
t1dds 1 2
To perform DDS service, use the following command, also for slot 1:
t1dds 1 1
3.Press the ENTER key. The unit automatically reboots and the user must
2.3.2WAN Configuration
The
Refer to the QuickSET manual for specific instructions on how to access the Wide Area configuration for the
For Local Management configuration, refer to Chapter 3 for T1 configuration, or Chapter 4 for DDS configuration.
The WAN configuration from QuickSET or either Chapter 3 or Chapter 4 must be completed before proceeding to the next step.
|