Cabletron Systems T1 manual Invalid

WAN Interface Configuration Screen

4.2WAN INTERFACE CONFIGURATION SCREEN

This section describes the features of the WAN Interface Configuration screen. Access the screen by using the arrow keys to highlight the WAN INT CONFIG command field at the bottom of the WAN Physical Configuration screen, then press ENTER. The WAN Interface Configuration screen shown in Figure 4-2displays.

<host name> Local Management								Flash Image Version: xx.xx.xx
			WAN INTERFACE CONFIGURATION
				CKT# IF#		LID	STATE	CKT# IF# LID STATE
Interface Number:		000		001	001	Enet	UP	017
Max Xmit Unit:		0
				002	002	Enet	DOWN	018
ProtMgrIface:		[0]		003				019
Active Protocol:		FR		004				020
FR LMI:		[ANSI_94]		005				021
DLCI Address:		0		006				022
DLCI DCP En:				007				023
DLCI DCP Stat:				008				024
Comp Ratio:				009				025
Circuit State:		[Invalid]		010				026
				011				027
				012				028
				013				029
				014
	PORTS:							030
SAVE		RETURN		015				031
	[1-32]			016				032

2750_02

Figure 4-2 WAN Interface Configuration Screen

4.2.1WAN Interface Configuration Screen Fields

The following sections describe WAN Interface Configuration screen fields.

Interface Number (Modifiable)

Displays the active Interface Number. Use this field to configure the Interface Number assigned to the timeslots on the WAN Physical Configuration screen.

Max Xmit Unit (Modifiable)

User configured field that displays the maximum packet size that can be transmitted on the selected interface. The default settings for this field (1526 for PPP and 4095 for Frame Relay) depend on the Protocol Manager selected.

WPIM-T1/DDS User’s Guide 4-5