Cabletron Systems manual T1 Interface Cabling

Page 61

T1 Interface Cabling

Table A-3 T1 RJ48 Connector Pin Assignments

Pin	Signal


1	Receive Ring

2	Receive Tip

3	Not Used

4	Transmit Ring

5	Transmit Tip

6	Not Used

7	Shield Ground

8	Shield Ground

Table A-4 T1 RJ48 DTE Pin Assignments

Pin	Signal


1	Receive Ring

2	Receive Tip

3	Not Used

4	Transmit Ring

5	Transmit Tip

6	Not Used

7	Shield Ground

8	Shield Ground

Table A-5 T1 RJ48 Network Pin Assignments

Pin	Signal


1	Receive Ring

2	Receive Tip

3	Not Used

4	Transmit Ring

5	Transmit Tip

6	Not Used

7	Not Used

8	Not Used

WPIM-T1/DDS User’s Guide

A-3

Image 61

Contents WPIM-T1/DDS User’s Guide Page WPIM-T1/DDS User’s Guide Industry Canada Notice Cabletron SYSTEMS, INC. Program License Agreement United States Government Restricted Rights Declaration of Conformity WPIM-T1/DDS User’s Guide Contents Viii WPIM-T1/DDS User’s Guide Introduction Using this ManualStructure of this Guide Related Manuals Following conventions are used throughout this document Document ConventionsYour email address Getting HelpChapter Overview Firmware Revision WPIM-T1/DDS FeaturesImportant Notice MIB Support WAN ProtocolsOverview WPIM-T1/DDS User’s Guide Installing the WPIM-T1/DDS Chapter Setup and InstallationUnpacking the WPIM-T1/DDS Installing the WPIM-T1/DDS Pre-InstallationInstalling the WPIM-T1/DDS Post-InstallationLEDs Choosing T1 or DDS ModeRequired Operations WAN Conﬁguration WAN Connection to the WPIM-T1/DDS Connecting the WAN Cable to the WPIM-T1/DDSChapter Local Management for T1 Service Wpim # WAN Physical Configuration ScreenWAN Physical Conﬁguration Screen Fields Saves the chosen conﬁguration Wpim Line Conﬁguration FieldsWpim Timeslot Conﬁguration Table Sample Timeslot Conﬁguration ANSI94 WAN Interface Configuration ScreenFrame Relay as the Protocol Manager WAN Interface Conﬁguration Screen FieldsWAN Interface Conﬁguration Screen PPP PPP as the Protocol ManagerCommand and Interface Table Fields Telco Conﬁguration Information Full T1 Configuration Using PPP1 T1 Service Physical Conﬁguration 2 T1 Interface Conﬁguration Fractional T1 Conﬁguration Fractional T1 Configuration Using PPP1 T1 Physical Conﬁguration Proceed to the .4.2 to continue configuration Frame Relay Conﬁguration Frame Relay ConfigurationFrame Relay Physical Conﬁguration Frame Relay Conﬁguration Frame Relay Interface Conﬁguration Frame Relay Conﬁguration WPIM-T1/DDS User’s Guide Chapter Local Management for DDS Service Local Management for DDS Service Displays conﬁguration information for two different WPIMs Not used for the WPIM-T1/DDS Invalid Refer to -2for the following parameters displayed for FR Refer to -3for the following parameters displayed for PPP Command and Interface Table Fields DDS Service Physical Conﬁguration DDS Service ConfigurationEnter DDS Service Interface ConﬁgurationDDS Service Conﬁguration WPIM-T1/DDS User’s Guide Physical Properties Appendix a SpecificationsEnvironmental Requirements Regulatory ComplianceCable Assemblies and Pinouts T1 Interface CablingT1 Interface Cabling DDS Port Assignment PIN SignalFCC Part 68 USER’S Information Appendix BAppendix B FCC Part 68 User’s Information Being duly sworn, state My commission expires