Cabletron Systems 9E106-06 manual Related Manuals, Getting Help

Page 13

Introduction

Related Manuals

The manuals listed below should be used to supplement the procedures and technical data contained in this manual.

SmartSwitch 9000 Installation Guide

SmartSwitch 9000 Operations Guide

SmartSwitch 9000 9C300-1 Environmental Module User’s Guide

SmartSwitch 9000 9C214-1 AC Power Supply User’s Guide

SmartSwitch 9000 Local Management User’s Guide

INB Terminator Modules Installation Guide

Getting Help

If you need additional support related to this device, or if you have any questions, comments, or suggestions concerning this manual, contact the Cabletron Systems Global Call Center:

Phone

(603) 332-9400

 

 

Internet mail

support@ctron.com

 

 

FTP

ctron.com (134.141.197.25)

Login

anonymous

Password

your email address

 

 

BBS

(603) 335-3358

Modem setting

8N1: 8 data bits, No parity, 1 stop bit

 

 

For additional information about Cabletron Systems or our products, visit our World Wide Web site: http://www.cabletron.com/

For technical support, select Service and Support.

Before calling the Cabletron Systems Global Call Center, have the following information ready:

Your Cabletron Systems service contract number

A description of the failure

A description of any action(s) already taken to resolve the problem (e.g., changing mode switches, rebooting the unit, etc.)

The serial and revision numbers of all involved Cabletron Systems products in the network

A description of your network environment (layout, cable type, etc.)

Network load and frame size at the time of trouble (if known)

The device history (i.e., have you returned the device before, is this a recurring problem, etc.)

Any previous Return Material Authorization (RMA) numbers

1-5

Image 13
Contents SmartSwitch 9E106-06 Ethernet Switch Module User’s Guide Page Page Vcci Notice FCC NoticeDOC Notice Page Contents Appendix a EPIMs Introduction Features Bridging/SecureFast Switching 9E106-06 Getting Help Related ManualsIntroduction Installing the 9E106-06 Module Installing the 9E106-06 Module Epim Revisions Installing EPIMsEpim Epim Board Revision Installing the EpimInstalling an Epim Reset SwitchReset Switch User-Accessible ComponentsUser-Accessible Components Setting the Module Card DIP SwitchLocation of Module DIP Switch See the Cautions at the end of this table Installing the 9E106-06 Module Six Front Panel Ports OperationSystem Management Buses System Diagnostic ControllerSMB-1 Bus SMB-10 BusDC/DC Converter I960 SwitchFNB Interface I960 HostOperation Lanview LEDs Lanview LEDsFunctions of the FNB Receive LED are listed in Table Functions of the Ethernet Receive LEDs are listed in Table Lanview LEDs Specifications SafetyTechnical Specifications MemoryDimensions ServiceWeight PhysicalEPIM-T EPIMsEPIM-F1 and EPIM-F2 Transmitter power parameters are listed Table A-2EPIM-F3 EPIM-C EPIM-A and EPIM-X AUI Port Connector TypeGrounding Table A-4lists the DB-15 pinouts