Cabletron Systems 9E106-06 manual Table A-4lists the DB-15 pinouts

Page 40

EPIMs

Figure A-5. The EPIM-A and EPIM-X

Table A-4lists the DB-15 pinouts.

Table A-4. DB-15 Pinouts

Pin Number	Represents	Pin Number	Represents

1	Logic Ref.	10	Transmit -

2	Collision +	11	Logic Ref.

3	Transmit	12	Receive -

4	Logic Ref.	13	Power (+12Vdc)

5	Receive	14	Logic Ref.

6	Power Return	15	No Connection

7	No Connection	Connector Shell	Positive Ground

9	Collision -

A-6

Image 40

Contents SmartSwitch 9E106-06 Ethernet Switch Module User’s Guide Page Page FCC Notice Vcci NoticeDOC Notice Page Contents Appendix a EPIMs Introduction Features Bridging/SecureFast Switching 9E106-06 Related Manuals Getting HelpIntroduction Installing the 9E106-06 Module Installing the 9E106-06 Module Installing EPIMs Epim RevisionsInstalling the Epim Epim Epim Board RevisionReset Switch Installing an EpimUser-Accessible Components Reset SwitchSetting the Module Card DIP Switch User-Accessible ComponentsLocation of Module DIP Switch See the Cautions at the end of this table Installing the 9E106-06 Module Operation Six Front Panel PortsSystem Diagnostic Controller System Management BusesSMB-1 Bus SMB-10 BusI960 Switch DC/DC ConverterFNB Interface I960 HostOperation Lanview LEDs Lanview LEDsFunctions of the FNB Receive LED are listed in Table Functions of the Ethernet Receive LEDs are listed in Table Lanview LEDs Safety SpeciﬁcationsTechnical Speciﬁcations MemoryService DimensionsWeight PhysicalEPIMs EPIM-TTransmitter power parameters are listed Table A-2 EPIM-F1 and EPIM-F2EPIM-F3 EPIM-C EPIM-A and EPIM-X AUI Port Connector TypeGrounding Table A-4lists the DB-15 pinouts