Cabletron Systems 9E106-06 manual

Page 3

Notice

Notice

Cabletron Systems reserves the right to make changes in specifications and other information contained in this document without prior notice. The reader should in all cases consult Cabletron Systems to determine whether any such changes have been made.

The hardware, firmware, or software described in this manual is subject to change without notice.

IN NO EVENT SHALL CABLETRON SYSTEMS BE LIABLE FOR ANY INCIDENTAL, INDIRECT, SPECIAL, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING BUT NOT LIMITED TO LOST PROFITS) ARISING OUT OF OR RELATED TO THIS MANUAL OR THE INFORMATION CONTAINED IN IT, EVEN IF CABLETRON SYSTEMS HAS BEEN ADVISED OF, KNOWN, OR SHOULD HAVE KNOWN, THE POSSIBILITY OF SUCH DAMAGES.

© Copyright February 1998 by:

Cabletron Systems, Inc.

35 Industrial Way

Rochester, NH 03867-5005

All Rights Reserved

Printed in the United States of America

Order Number: 9031346-01 February 1998

SPECTRUM, Remote LANVIEW and LANVIEW are registered trademarks and SecureFast and SmartSwitch are trademarks of Cabletron Systems, Inc.

Ethernet is a trademark of Xerox Corporation and i960 is a registered trademark of Intel Corporation.

i

Page 2 Page 4
Image 3
Page 2 Page 4
Contents SmartSwitch 9E106-06 Ethernet Switch Module User’s Guide Page Page Vcci Notice FCC NoticeDOC Notice Page Contents Appendix a EPIMs Introduction Features Bridging/SecureFast Switching 9E106-06 Getting Help Related ManualsIntroduction Installing the 9E106-06 Module Installing the 9E106-06 Module Epim Revisions Installing EPIMsEpim Epim Board Revision Installing the EpimInstalling an Epim Reset SwitchReset Switch User-Accessible ComponentsUser-Accessible Components Setting the Module Card DIP SwitchLocation of Module DIP Switch See the Cautions at the end of this table Installing the 9E106-06 Module Six Front Panel Ports OperationSMB-10 Bus System Diagnostic ControllerSystem Management Buses SMB-1 BusI960 Host I960 SwitchDC/DC Converter FNB InterfaceOperation Lanview LEDs Lanview LEDsFunctions of the FNB Receive LED are listed in Table Functions of the Ethernet Receive LEDs are listed in Table Lanview LEDs Memory SafetySpecifications Technical SpecificationsPhysical ServiceDimensions WeightEPIM-T EPIMsEPIM-F1 and EPIM-F2 Transmitter power parameters are listed Table A-2EPIM-F3 EPIM-C Connector Type EPIM-A and EPIM-X AUI PortGrounding Table A-4lists the DB-15 pinouts
Top Page Image Contents