Cabletron Systems 9E106-06 manual Lanview LEDs

Page 29

Chapter 4

LANVIEW LEDs

The front panel LANVIEW LEDs indicate the status of the module and may be used as an aid in troubleshooting. The 9E106-06 LANVIEW LEDs are shown in Figure 4-1.

Diagnostic Controller Status

FNB Receive

ETHERNET
9E106-06
SMB	CPU
FNB

System Status

FNB Transmit

Ethernet

Receive

Ethernet

Transmit

Figure 4-1. The LANVIEW LEDs

4-1

Image 29

Contents SmartSwitch 9E106-06 Ethernet Switch Module User’s Guide Page Page Vcci Notice FCC NoticeDOC Notice Page Contents Appendix a EPIMs Introduction Features Bridging/SecureFast Switching 9E106-06 Getting Help Related ManualsIntroduction Installing the 9E106-06 Module Installing the 9E106-06 Module Epim Revisions Installing EPIMsEpim Epim Board Revision Installing the EpimInstalling an Epim Reset SwitchReset Switch User-Accessible ComponentsUser-Accessible Components Setting the Module Card DIP SwitchLocation of Module DIP Switch See the Cautions at the end of this table Installing the 9E106-06 Module Six Front Panel Ports OperationSystem Management Buses System Diagnostic ControllerSMB-1 Bus SMB-10 BusDC/DC Converter I960 SwitchFNB Interface I960 HostOperation Lanview LEDs Lanview LEDsFunctions of the FNB Receive LED are listed in Table Functions of the Ethernet Receive LEDs are listed in Table Lanview LEDs Speciﬁcations SafetyTechnical Speciﬁcations MemoryDimensions ServiceWeight PhysicalEPIM-T EPIMsEPIM-F1 and EPIM-F2 Transmitter power parameters are listed Table A-2EPIM-F3 EPIM-C Grounding Connector TypeEPIM-A and EPIM-X AUI Port Table A-4lists the DB-15 pinouts