Cabletron Systems 9E106-06 manual Reset Switch, Installing an Epim

Page 19

Installing the 9E106-06 Module

Mounting

Screw

Figure 2-3. Installing an EPIM

The Reset Switch

The Reset Switch is located on the front panel, under the top plastic tab, as shown in Figure 2-4.It serves two functions:

•Pressing the Reset Switch twice within three seconds resets the module.

•Pressing and holding the switch on for three or more seconds causes the module to shutdown. Pressing and holding the switch again for three seconds restarts the module.

SNMP management may be used to disable this switch to enhance module security.

2-5

Image 19

Contents SmartSwitch 9E106-06 Ethernet Switch Module User’s Guide Page Page Vcci Notice FCC NoticeDOC Notice Page Contents Appendix a EPIMs Introduction Features Bridging/SecureFast Switching 9E106-06 Getting Help Related ManualsIntroduction Installing the 9E106-06 Module Installing the 9E106-06 Module Epim Revisions Installing EPIMsEpim Epim Board Revision Installing the EpimInstalling an Epim Reset SwitchReset Switch User-Accessible ComponentsUser-Accessible Components Setting the Module Card DIP SwitchLocation of Module DIP Switch See the Cautions at the end of this table Installing the 9E106-06 Module Six Front Panel Ports OperationSMB-10 Bus System Diagnostic ControllerSystem Management Buses SMB-1 BusI960 Host I960 SwitchDC/DC Converter FNB InterfaceOperation Lanview LEDs Lanview LEDsFunctions of the FNB Receive LED are listed in Table Functions of the Ethernet Receive LEDs are listed in Table Lanview LEDs Memory SafetySpeciﬁcations Technical SpeciﬁcationsPhysical ServiceDimensions WeightEPIM-T EPIMsEPIM-F1 and EPIM-F2 Transmitter power parameters are listed Table A-2EPIM-F3 EPIM-C EPIM-A and EPIM-X AUI Port Connector TypeGrounding Table A-4lists the DB-15 pinouts