Cabletron Systems 9E106-06 manual See the Cautions at the end of this table

Installing the 9E106-06 Module

See the Cautions at the end of this table.

!

CAUTION

		Table 2-2. Function of DIP Switch
Switch	Function	Description
		This module stores user entered passwords in NVRAM
		(Nonvolatile Random Access Memory). To clear these
	Clear	passwords, toggle this switch and then reset the module’s
8		processor. Once the module resets, factory default passwords
	Password-1
		are placed in NVRAM. You can use these default passwords
		or, if desired, enter new passwords. To enter new passwords,
		refer to the Module Local Management User’s Guide.
		This module stores user entered parameters such as IP
		addresses, subnet masks, default gateway, default interface,
		SNMP traps, bridge configurations and module specific
	Clear	configurations in NVRAM. To clear these parameters toggle
7		this switch and then reset the module’s processor. Once the
	NVRAM-2
		module resets, factory default parameters are placed in
		NVRAM. You can use the default parameters or, if desired,
		enter new parameters. To enter new parameters, refer to the
		Module Local Management User’s Guide.
		This module uses BOOTP (Boot Strap Protocol) to download
	Force	new versions of the image file into Flash Memory. This
6	BOOTP	procedure forces image files to be downloaded from the PC
	Download	or Workstation, configured to act as the BOOTP server,
		connected to the EPIM port in the Environmental Module.
5	Reserved	For Factory Use Only
4	Reserved	For Factory Use Only
3	Reserved	For Factory Use Only
2	Reserved	For Factory Use Only
1	Reserved	For Factory Use Only

Caution: Do not toggle Switch 8 unless you intend to reset the user configured passwords to the factory default settings.

Caution: Do not toggle Switch 7 unless you intend to reset the user parameters to the factory default settings.

2-9