Cabletron Systems manual Installing the 9E106-06 Module

Page 16

Installing the 9E106-06 Module

Plastic Tab

Jack for ESD

Wrist Strap

Metal Back-Panel

Module

Module Guides

Figure 2-1. Installing the 9E106-06 Module

WARNING

2-2

Ensure that the module is between the module guides. Lock down the top and bottom plastic tabs at the same time, applying even pressure.

Image 16

Contents SmartSwitch 9E106-06 Ethernet Switch Module User’s Guide Page Page FCC Notice Vcci NoticeDOC Notice Page Contents Appendix a EPIMs Introduction Features Bridging/SecureFast Switching 9E106-06 Related Manuals Getting HelpIntroduction Installing the 9E106-06 Module Installing the 9E106-06 Module Installing EPIMs Epim RevisionsInstalling the Epim Epim Epim Board RevisionReset Switch Installing an EpimUser-Accessible Components Reset SwitchSetting the Module Card DIP Switch User-Accessible ComponentsLocation of Module DIP Switch See the Cautions at the end of this table Installing the 9E106-06 Module Operation Six Front Panel PortsSystem Diagnostic Controller System Management BusesSMB-1 Bus SMB-10 BusI960 Switch DC/DC ConverterFNB Interface I960 HostOperation Lanview LEDs Lanview LEDsFunctions of the FNB Receive LED are listed in Table Functions of the Ethernet Receive LEDs are listed in Table Lanview LEDs Safety SpeciﬁcationsTechnical Speciﬁcations MemoryService DimensionsWeight PhysicalEPIMs EPIM-TTransmitter power parameters are listed Table A-2 EPIM-F1 and EPIM-F2EPIM-F3 EPIM-C EPIM-A and EPIM-X AUI Port Connector TypeGrounding Table A-4lists the DB-15 pinouts