Cabletron Systems 9E106-06 manual Contents

Page 7

Contents

Chapter 1	Introduction
	Features	1-2
	Related Manuals	1-5
	Getting Help	1-5

Chapter 2	Installing the 9E106-06 Module
	Installing EPIMs	2-3
	EPIM Revisions	2-3
	Installing the EPIM	2-4
	The Reset Switch	2-5
	User-Accessible Components	2-6
	Setting the Module Card DIP Switch	2-7

Chapter 3	Operation
	System Management Buses	3-2
	SMB-1 Bus	3-2
	SMB-10 Bus	3-2
	System Diagnostic Controller	3-2
	DC/DC Converter	3-3
	FNB Interface	3-3
	i960 Switch	3-3
	i960 Host	3-3
Chapter 4	LANVIEW LEDs
Chapter 5	Speciﬁcations
	Technical Speciﬁcations	5-1
	CPU:	5-1
	Memory:	5-1
	Network Interfaces:	5-1
	Safety	5-1
	Service	5-2
	Physical	5-2
	Dimensions:	5-2
	Weight:	5-2

v

Image 7

Contents SmartSwitch 9E106-06 Ethernet Switch Module User’s Guide Page Page Vcci Notice FCC NoticeDOC Notice Page Contents Appendix a EPIMs Introduction Features Bridging/SecureFast Switching 9E106-06 Getting Help Related ManualsIntroduction Installing the 9E106-06 Module Installing the 9E106-06 Module Epim Revisions Installing EPIMsEpim Epim Board Revision Installing the EpimInstalling an Epim Reset SwitchReset Switch User-Accessible ComponentsUser-Accessible Components Setting the Module Card DIP SwitchLocation of Module DIP Switch See the Cautions at the end of this table Installing the 9E106-06 Module Six Front Panel Ports OperationSMB-10 Bus System Diagnostic ControllerSystem Management Buses SMB-1 BusI960 Host I960 SwitchDC/DC Converter FNB InterfaceOperation Lanview LEDs Lanview LEDsFunctions of the FNB Receive LED are listed in Table Functions of the Ethernet Receive LEDs are listed in Table Lanview LEDs Memory SafetySpeciﬁcations Technical SpeciﬁcationsPhysical ServiceDimensions WeightEPIM-T EPIMsEPIM-F1 and EPIM-F2 Transmitter power parameters are listed Table A-2EPIM-F3 EPIM-C EPIM-A and EPIM-X AUI Port Connector TypeGrounding Table A-4lists the DB-15 pinouts