Cabletron Systems 9E106-06 manual Functions of the Ethernet Receive LEDs are listed in Table

Page 31

LANVIEW LEDs

The functions of the Ethernet Receive LEDs are listed in Table 4-1.

	Table 4-4. Ethernet Receive LEDs

LED Color	State

Green	Link, No activity

Yellow (Flashing)	Link, Activity (Flashing rate indicates rate of activity.)

Red	Port disabled no link

Red (Flashing)	Port disabled with link

Off	No link, No activity

The functions of the Ethernet Transmit LEDs are listed in Table 4-5.

	Table 4-5. Ethernet Transmit LEDs

LED Color	State

Green (Flashing)	Activity (Flashing rate indicates rate of activity)

Yellow (Flashing)	Port in standby state

Red	Port disabled

Red (Flashing)	Collision

Off	No activity

4-3

Image 31

Contents SmartSwitch 9E106-06 Ethernet Switch Module User’s Guide Page Page Vcci Notice FCC NoticeDOC Notice Page Contents Appendix a EPIMs Introduction Features Bridging/SecureFast Switching 9E106-06 Getting Help Related ManualsIntroduction Installing the 9E106-06 Module Installing the 9E106-06 Module Epim Revisions Installing EPIMsEpim Epim Board Revision Installing the EpimInstalling an Epim Reset SwitchReset Switch User-Accessible ComponentsUser-Accessible Components Setting the Module Card DIP SwitchLocation of Module DIP Switch See the Cautions at the end of this table Installing the 9E106-06 Module Six Front Panel Ports OperationSMB-10 Bus System Diagnostic ControllerSystem Management Buses SMB-1 BusI960 Host I960 SwitchDC/DC Converter FNB InterfaceOperation Lanview LEDs Lanview LEDsFunctions of the FNB Receive LED are listed in Table Functions of the Ethernet Receive LEDs are listed in Table Lanview LEDs Memory SafetySpeciﬁcations Technical SpeciﬁcationsPhysical ServiceDimensions WeightEPIM-T EPIMsEPIM-F1 and EPIM-F2 Transmitter power parameters are listed Table A-2EPIM-F3 EPIM-C EPIM-A and EPIM-X AUI Port Connector TypeGrounding Table A-4lists the DB-15 pinouts