Cabletron Systems 9E106-06 manual Setting the Module Card DIP Switch, User-Accessible Components

Page 21

Installing the 9E106-06 Module

SMB-1

PROM

Dip

Switch

Boot

PROM

Local

DRAM

Socket

Packet

DRAM

Socket

Flash

SIMM

Socket

Figure 2-5. User-Accessible Components

Setting the Module Card DIP Switch

An eight-switch DIP switch is located on the module card, as shown in Figure 2-5and Figure 2-5.The functions of the switches are listed in Table 2-2.

2-7

Image 21

Contents SmartSwitch 9E106-06 Ethernet Switch Module User’s Guide Page Page Vcci Notice FCC NoticeDOC Notice Page Contents Appendix a EPIMs Introduction Features Bridging/SecureFast Switching 9E106-06 Getting Help Related ManualsIntroduction Installing the 9E106-06 Module Installing the 9E106-06 Module Epim Revisions Installing EPIMsEpim Epim Board Revision Installing the EpimInstalling an Epim Reset SwitchReset Switch User-Accessible ComponentsUser-Accessible Components Setting the Module Card DIP SwitchLocation of Module DIP Switch See the Cautions at the end of this table Installing the 9E106-06 Module Six Front Panel Ports OperationSystem Management Buses System Diagnostic ControllerSMB-1 Bus SMB-10 BusDC/DC Converter I960 SwitchFNB Interface I960 HostOperation Lanview LEDs Lanview LEDsFunctions of the FNB Receive LED are listed in Table Functions of the Ethernet Receive LEDs are listed in Table Lanview LEDs Speciﬁcations SafetyTechnical Speciﬁcations MemoryDimensions ServiceWeight PhysicalEPIM-T EPIMsEPIM-F1 and EPIM-F2 Transmitter power parameters are listed Table A-2EPIM-F3 EPIM-C Connector Type EPIM-A and EPIM-X AUI PortGrounding Table A-4lists the DB-15 pinouts