Cabletron Systems 9E106-06 manual FCC Notice, Vcci Notice

Page 4

Notice

FCC Notice

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment uses, generates, and can radiate radio frequency energy and if not installed in accordance with the operator’s manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause interference in which case the user will be required to correct the interference at his own expense.

WARNING: Changes or modifications made to this device which are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

VCCI Notice

This equipment is in the 1st Class Category (information equipment to be used in commercial and/or industrial areas) and conforms to the standards set by the Voluntary Control Council for Interference by Information Technology Equipment (VCCI) aimed at preventing radio interference in commercial and/or industrial areas.

Consequently, when used in a residential area or in an adjacent area thereto, radio interference may be caused to radios and TV receivers, etc.

Read the instructions for correct handling.

ii

Image 4
Contents SmartSwitch 9E106-06 Ethernet Switch Module User’s Guide Page Page FCC Notice Vcci NoticeDOC Notice Page Contents Appendix a EPIMs Introduction Features Bridging/SecureFast Switching 9E106-06 Related Manuals Getting HelpIntroduction Installing the 9E106-06 Module Installing the 9E106-06 Module Installing EPIMs Epim RevisionsInstalling the Epim Epim Epim Board RevisionReset Switch Installing an EpimUser-Accessible Components Reset SwitchSetting the Module Card DIP Switch User-Accessible ComponentsLocation of Module DIP Switch See the Cautions at the end of this table Installing the 9E106-06 Module Operation Six Front Panel PortsSystem Diagnostic Controller System Management BusesSMB-1 Bus SMB-10 BusI960 Switch DC/DC ConverterFNB Interface I960 HostOperation Lanview LEDs Lanview LEDsFunctions of the FNB Receive LED are listed in Table Functions of the Ethernet Receive LEDs are listed in Table Lanview LEDs Safety SpecificationsTechnical Specifications MemoryService DimensionsWeight PhysicalEPIMs EPIM-TTransmitter power parameters are listed Table A-2 EPIM-F1 and EPIM-F2EPIM-F3 EPIM-C EPIM-A and EPIM-X AUI Port Connector TypeGrounding Table A-4lists the DB-15 pinouts