Extron electronic ISM 182 manual Executive mode, Verbose mode, Information requests

Programmer’s Guide, cont’d

Command/response table for SIS commands (cont’d)

Command	ASCII Command	Response		Additional description
	(host to switcher)	(switcher to host)
Executive mode
Enable (lock image adjustments)	1X	Exe1		Lock front panel adjustments;
				adjust image via RS-232 only.
Disable	0X	Exe0		Adjustments & selections can
				be made from the front panel.
View the executive mode status	X		X3	Show executive mode status.
Example:	X	0		Executive mode is off.

Verbose mode

The default for verbose mode is on for the RS-232 connection and off for Ethernet connections.

Disable (block reports)

Esc	0CV	Vrb0	Turn off verbose mode. The ISM
			does not send the reports listed
			in switcher-initiated messages
			earlier in this chapter.

Disable verbose mode blocks reports for front panel operations only to this connection (RS-232 or Ethernet) only. The ISM continues to send responses to SIS commands to all ports. The ISM continues to send reports for front panel operations to other connections.

Enable (allow reports)

View the executive mode status Example:

Esc	1CV	Vrb1		Turn on verbose mode. The ISM
				sends all reports.
	CV			Show verbose mode status.
Esc			X3
	CV	1		Verbose mode is on (the ISS
Esc
				issues reports).

Information requests

Query firmware version number	Q		x.xx
Request part number	N		zz-zzz-zz
Request general information		I	(See below)
	X2
			Vid		•Aud
				X1

Show the controller firmware version.

Show the ISM’s part #. Show the ISM’s status.

X1 •Frz X3 •Hrt X25 •Vrt X25 •Std X26

The response to the View File Directory command differs, depending on whether the command is sent via an RS-232 or Telnet connection or sent via a Web browser connection.

View file directory (RS-232)

View file directory (Web)

Esc	DF	filename date/time length
		filename date/time length
		filename date/time length
		filename date/time length
		nnnn Bytes Left
	DF	Switcher response
Esc

File [1] = ‘filename1, date1, filesize1’; File [2] = ‘filename2, date2, filesize2’; File [3] = ‘filename3, date3, filesize3’; File [4] = ‘filename4, date4, filesize4’; File [n] = ‘filenamen, daten, filesizen’;

4-12 Integration Scaling Matrix Switcher • Programmer’s Guide