Extron electronic ISM 182 manual Ping to determine the switcher’s IP address

Page 81

Default address

To access the ISM switcher via the Ethernet port, you will need the Extron ISM IP address. If the address has been changed to an address comprised of words and characters, the actual numeric IP address can be determined using the Ping utility. If the address has not been changed, the factory-specified default is 192.168.254.254.

Ping can also be used to test the Ethernet link to the ISM.

Ping to determine the switcher’s IP address

The Microsoft Ping utility is available at the DOS prompt. Ping tests the Ethernet interface between the computer and the ISM. Ping can also be used to determine the actual numeric IP address from an alias and to determine the web address.

Access the DOS prompt and Ping the switcher as follows:

1.	Click on Start > Run.
2.	At the Open prompt, type command.
3.	Click on the OK button.
4.	At the DOS prompt, type ping {IP address} and press [Enter]. The computer
	returns a display similar to figure A-2.
	The line Pinging ... reports the actual numeric IP address, regardless of
	whether you entered the actual numeric IP address or an alias name.

C:\>ping 192.168.254.254

Pinging 192.168.254.254 with 32 bytes of data:

Reply from 192.168.254.254: bytes=32 time<10ms TTL=128

Reply from 192.168.254.254: bytes=32 time<10ms TTL=128

Reply from 192.168.254.254: bytes=32 time<10ms TTL=128

Reply from 192.168.254.254: bytes=32 time<10ms TTL=128

Ping statistics for 192.168.254.254:

Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),

Approximate round trip times in milli-seconds:

Minimum = 0ms, Maximum = 0ms, Average = 0ms

Figure A-2 — Ping response

Ping to determine the Web IP address

The Ping utility has a modifier, -a, that directs the command to return the Web address rather than the numeric IP address.

At the DOS prompt, type ping -a {IP address} and then press [Enter]. The computer’s return display is similar to the Ping response shown in figure A-2, except that when you specify the -amodifier, the line Pinging mail... reports the web IP address rather than the numeric IP address, regardless of whether you entered the actual numeric IP address or an alias name.

Integration Scaling Matrix Switcher • Ethernet Connection

A-3

Image 81

Contents ISM 482 & ISM Integration Scaling Matrix SwitchersConsignes de Sécurité Français Safety Instructions EnglishSicherheitsanleitungen Deutsch Instrucciones de seguridad EspañolQS-1 Quick Start Integration Scaling Matrix SwitcherQS-2 Quick Start Integration Scaling Matrix Switcher, cont’dTable of Contents Table of Contents, cont’d Integration Scaling Matrix Switcher Table of Contents Iii Iv Integration Scaling Matrix Switcher Table of Contents One Integration Scaling Matrix Switcher Introduction About the SwitcherIntroductiontroduction, cont’d About this ManualExtron ISM Introduction, cont’d FeaturesIntegration Scaling Matrix Switcher Introduction Introduction, cont’d Two Mounting the Switcher Installationstallation, cont’dTabletop placement Integration Scaling Matrix Switcher InstallationInput connections Cabling and Rear Panel ViewsCaptive screw connector wiring for inputs Installation, cont’dBNC output connections for Rgbhv and Rgbs video Output connectionsCabling and RJ-45 connector wiring Ethernet connectionChoosing a network cable RJ-45 connector pinout tables Wiring the network cableRS-232 connection ConfigurationThree Integration Scaling Matrix Switcher Operation Front Panel Controls and IndicatorsOperationeration, cont’d Video/Audio selection button and LEDsOutputs buttons and LEDs Input buttons, LEDs, and label windowFront panel input label window Picture adjustment buttons Operation, cont’dBlack/Mute button and LEDs Adjustment knobs LCD displayMenu control buttons Front Panel Operations PowerExtron Electronics ISM 60-425-01 Version Menu system overviewInput Configuration submenu Video & Audio Configuration menuOutput Resolution submenu Output Configuration menuSync Type and Polarity submenu Resolution 50 Hz 56 Hz 60 Hz 75 Hz 85 Hz Lock at 50/60 HzVideo & Audio Advanced Configuration menuRGB Delay submenu Blue Only Mode and Edge Smoothing submenuTest Pattern submenu Blanking submenuPixel Phase submenu Enhanced Mode submenuPAL Film Mode submenu Reset submenuSave Preset submenu User Presets menuExit menu Erase Preset submenu13 Picture adjustments flowchart Picture adjustments14 Front panel security lockout flowchart Front panel security lockout executive modeIP information Optimizing the VideoControls to position the image Setting up a DVD sourceTroubleshooting Optimizing the AudioGeneral checks Problem Cause Specific problemsOperation, cont’d Four Integration Scaling Matrix Switcher Programmer’s Guide RS-232 LinkEthernet Link Default address SymbolsPower-up Switcher-Initiated MessagesTies creation Input and output video typeX2 Col Programmer’s Guide, cont’d Host-to-Switcher Instructions Switcher error responsesUsing the command/response table Command Ascii Command Response Additional description Contrast BrightnessHorizontal size Vertical sizeBottom blanking Pixel phaseHorizontal detail filter RGB and component video inputs Vertical detail filter RGB and component video inputsAuto Memories User presetsFreeze Test patternExecutive mode Verbose modeInformation requests Resets Command/response table for IP SIS commandsCommand/response table for special function SIS commands Delay timesScaler settings PAL film mode Enhanced modeBlue screen Edge smoothingCommand Hex Command Response Memory backupAdditional description Five Ethernet protocol settings Installing the softwareIntegration Scaling Matrix Switcher Switcher Software Control Software for WindowsIf you selected a comm port, proceed to step Using the control programWindows Control program window Switcher Software, cont’dButton-Label Generator Using the help programUsing the software Installing the softwareSix Integration Scaling Matrix Switcher Ethernet Operation EthernetOperation,cont’dLoad the Startup Control Control Ethernet Operation, cont’d Change the RGB delayControl Create a tieFreeze the output Executive modeOutput a test pattern Preview the scan rateSystem Configuration System ConfigurationISM IP Settings fields Administration fieldsISM IP Address field ISM Name fieldFile Management File ManagementI/O Configuration Input configurationOutput resolution, rate, sync format, and polarity Output rate Output resolutionOutput polarity Output formatAAppendix a Ethernet Connection, cont’d Integration Scaling Matrix Switcher Ethernet ConnectionPing to determine the Web IP address Ping to determine the switcher’s IP addressConnect as a Telnet client Telnet tipsOpen Local echo Escape character and Esc keySet carriage return-line feed CloseEthernet Connection, cont’d AppendixBB Integration Scaling Matrix Switcher Reference Information SpecificationsAudio Cables and connectors Optional accessoriesReference Information, cont’d Part NumbersBNC-4 Mini HR Cable Assorted connectors BNC connectorsBNC-5 Mini HR Cable Plenum BNC-5 Mini HR CableFirmware Upgrade Installation Figure B-1 Removing the ISM cover Button Labels Integration Scaling Matrix Switcher Reference Information Reference Information, cont’d FCC Class B Notice Extron Electronics, USA

Related manuals

Manual 3 pages 47.89 Kb