Network Technologies CS-16/8 Modem settings, Copy Port Serial Settings, Function Keystroke

NTI RACK MOUNT CONSOLE TERMINAL WITH CONSOLE SWITCH

3.1.3.1.10Copy Port Serial Settings

–Press [+] to select the current port as source in a port settings copy-paste process (except port 0).

–Then, press [*] to paste the port settings.

–Press [Y] to paste the selected port settings to the current port, [A] to paste to all ports, [S] to specify the destination port, or press any other key to cancel.

3.1.3.1.11Display serial settings for different port number

Press [>] (greater than symbol) to display the next higher port serial settings, or press [<] (less than symbol) to display the previous port serial settings.

Press [Esc] or [Space] to return to the "Port settings" menu.

3.1.3.2 Modem settings

From the "Port settings" menu, press [6] to display the "Modem settings" menu.

Remote connections are possible if modems are used, usually by the users. The remote modem may call in to a local modem attached to a SERIMUX port. A minimum number of port modem settings can be adjusted in the SERIMUX to control the connection (try the default values first; refer to the manual(s) for the modems otherwise).

Figure 13- Modem settings menu

The administrator can initialize a modem attached to a SERIMUX port, or disconnect the modem. To control the modem connection from the "Modem settings" menu, the following functions are possible:

Function	Keystroke
Attach and initialize a modem	[1] - [A]	FYI: If an old modem is attached to a SERIMUX port, it may
Disconnect a modem	[1] - [D]
		be necessary to enable the “Hang-up on “NO CARRIER”
Change the modem reset string	[2]
		message” option, in order to hang-up and disconnect the
Change the initialization string	[3]
		attached modem when receiving this message. Press [5],
Change the hangup string	[4]
		then [Y] to enable or any other key to disable this option.
Enable hangup on "NO CARRIER"	[5]
		Usually, this option should remain disabled.
Save the changes	[Enter]
Cancel the command	[Esc]
Reset to default values	[0]-[Y]

.

–Press [+] to select the current port as source in a port modem settings copy-paste process (except port 0).

–Then, press [*] to paste the port settings.

–Press [Y] to paste the selected port settings to the current port, [A] to paste to all ports, [S] to specify the destination port, or press any other key to cancel.

18