Network Technologies CS-16/8 2 VT52 Command Guide, See table below for values of Ps, Command VT52

NTI RACK MOUNT CONSOLE TERMINAL WITH CONSOLE SWITCH

Supported VT100, VT220 and Console ANSI Commands, Cont'd

							Command
	FUNCTION				VT100, VT220			Console ANSI
	Request keyboard status report			CSI ? 26 n					Same
	Respond with keyboard language			CSI ? 27; Ps n					Same
	(see table below for values of “Ps”)
	Values of Ps (above)
	Ps	Keyboard Language	Ps			Keyboard Language
1		U.S.	6			Spanish
2		U.K.	7			Swedish
3		Danish	8			Norwegian
4		German	9			Italian
5		French

*1. More than one mode, but less than 17, may be set with one sequence. Enter multiple numeric parameters separated by semicolons (;). However you cannot combine sequences containing "?" with those that don't contain "?", nor can you combine sequences ending with "h" with those ending with "l".

*2. To toggle monitor mode from the keyboard, press CTRL SHIFT 1 (use the 1 on the numeric keypad).

*3. In VT52 or VT100 modes, displays checkerboard character.

4.5.2 VT52 Command Guide

Table 8- VT52 Mode Escape Sequences

Command	VT52
Move cursor up one line	ESC A
Move cursor down one line	ESC B
Move cursor right one column	ESC C
Move cursor left one column	ESC D
Move cursor to home position	ESC H
Move cursor up one line with scroll	ESC I
Move cursor to line line, column col	ESC Y line col
Select graphics character set	ESC F
Select U.S. ASCII character set	ESC G
Erase from cursor to end of display	ESC J
Erase from cursor to end of line	ESC K
Print cursor line	ESC V
Print display	ESC ]
Transparent print mode on	ESC W
Transparent print mode off	ESC X
Copy print mode on	ESC ^
Copy print mode off	ESC _
Keypad application mode on	ESC =
Keypad application mode off	ESC >
Enter VT100 mode	ESC <
Identify terminal	ESC Z

64