Quatech manual Using DSE-410D Manager, Searching LAN for DSE-410D

Page 25

4 Using DSE-410D Manager

The DSE-410D Manager software performs several functions:

Searches the LAN for installed DSE-410D Servers

Configures the DSE-410D Server for operation

Uninstalls Virtual COM ports

Configures Virtual COM ports

Upgrades Firmware

1.Connect the DSE-410D to the LAN using a standard Cat 5 Ethernet cable, or to the LAN port on your computer using an Ethernet crossover cable.

2.Apply power. The Red Power indicator will light, the Link indicator lights when an Ethernet connection is made, and the Ready indicator will flash. See the Hardware chapter for more information.

The DSE-410D Manager software can now be started and used to Search for all connected DSE-410D Server. Each Server will be found and displayed by name and IP address in the Server Window.

Searching LAN for DSE-410D

1.Select the DSE-410D Manager from your Programs menu. Use Start/Programs/Quatech/SDS/DSE-410D/DSE-410D Manager.

Document Number: 940-0186-100 – DSE-410D Owner’s Manual

19

Quatech, Inc. - 5675 Hudson Industrial Parkway, Hudson, OH 44236 – 330.655.9000

http://www.quatech.com

Image 25

Contents World Headquarters Model DSE-410DPage Table of Contents Searching LAN for DSE-410D Server Name PasswordMAC Address Installing Virtual Com Port Page Introduction FeaturesVirtual COM Mode Direct IP ModeCommunication Modes Quick Start Heart Beat ConnectionDhcp Default DSE-410D SettingsSpecifications Optional Accessories DimensionsConfiguration Options Hardware Side View when vertically mountedEthernet Connection Light IndicationReset Button Power ConnectionMode Switches DSE-410D Server Port Top ViewRS-422 Mode RS-485 ModeRS-232 Mode Default SettingSerial Connections RS-232 Connections RS-422 Connections RS-485 Connections Page Install Quatech DSE-410D Software Page Page Page Searching LAN for DSE-410D Using DSE-410D ManagerVirtual COM Configuration Firmware UpgradeUninstall Virtual COM Searching ServerCOM Name ProtocolStatus Server Properties ScreenNext chapter Server Properties Configuration Server Name PasswordIP Address, Netmask, and Gateway Properties MAC Address Link Status Shown in Telnet or Console mode onlyServer Serial Port Select 1 or Baud Rate Set for each portFlow Control Set for each port Connection Mode Set for each portTCP/UDP Protocol Set for each port TCP/UDP Port Set for each portUpdate Page Installing Virtual Com Port Page Page Use Device Manager to View New Ports Page Page Removing a Virtual Com Port Removing the Virtual COM Port using Device Manager Page Page Using Virtual COM or Serial Connections Upgrade ModePage Page Page Console Mode Setup Page Appendix a RS-232, RS-422 Loopback Connections Page DB9M Appendix B RS-232 ConnectionsRS-232 Connections cont’d Appendix C RS-422 Connections Signal Name Direction PinRS-422 Connections cont’d Appendix D RS-485 Connections Page Appendix E Warranty Date of Purchase Model Number