Quatech DSE-410D manual

Page 47

8.Next a serial menu is shown so you can match the Upgrade mode settings to DSE-410D Server serial settings (which you noted in Server Properties). The settings must match or the upgrade will fail.

9.Upgrade progress will be shown until the Upgrade was successful message is shown. Select and exit from the Manager software.

10.When the upgrade is complete reset server. Use Telnet, Hyper Terminal Winsock or Console mode to access the menu. Once the menu is open select the reset button. When the DSE-410D is reset the build date listed at the bottom of the menu will reflect the new firmware version.

Document Number: 940-0186-100 – DSE-410D Owner’s Manual

41

Quatech, Inc. - 5675 Hudson Industrial Parkway, Hudson, OH 44236 – 330.655.9000

http://www.quatech.com

Image 47

Contents World Headquarters Model DSE-410DPage Table of Contents MAC Address Server Name PasswordSearching LAN for DSE-410D Installing Virtual Com Port Page Introduction FeaturesCommunication Modes Direct IP ModeVirtual COM Mode Quick Start Heart Beat ConnectionDhcp Default DSE-410D SettingsSpecifications Configuration Options DimensionsOptional Accessories Light Indication Side View when vertically mountedHardware Ethernet ConnectionTop View Power ConnectionReset Button Mode Switches DSE-410D Server PortDefault Setting RS-485 ModeRS-422 Mode RS-232 ModeSerial Connections RS-232 Connections RS-422 Connections RS-485 Connections Page Install Quatech DSE-410D Software Page Page Page Searching LAN for DSE-410D Using DSE-410D ManagerSearching Server Firmware UpgradeVirtual COM Configuration Uninstall Virtual COMServer Properties Screen ProtocolCOM Name StatusNext chapter Server Properties Configuration IP Address, Netmask, and Gateway Properties PasswordServer Name Baud Rate Set for each port Link Status Shown in Telnet or Console mode onlyMAC Address Server Serial Port Select 1 orTCP/UDP Port Set for each port Connection Mode Set for each portFlow Control Set for each port TCP/UDP Protocol Set for each portUpdate Page Installing Virtual Com Port Page Page Use Device Manager to View New Ports Page Page Removing a Virtual Com Port Removing the Virtual COM Port using Device Manager Page Page Using Virtual COM or Serial Connections Upgrade ModePage Page Page Console Mode Setup Page Appendix a RS-232, RS-422 Loopback Connections Page DB9M Appendix B RS-232 ConnectionsRS-232 Connections cont’d Appendix C RS-422 Connections Signal Name Direction PinRS-422 Connections cont’d Appendix D RS-485 Connections Page Appendix E Warranty Date of Purchase Model Number