Quatech DSE-410D manual MAC Address, Link Status Shown in Telnet or Console mode only

Page 31

DHCP reassigns a different IP address, the software will not be able to communicate with the hardware. We recommend using a static IP address.

Net Mask

The default LAN net mask is configured for a Class C address. The user can change this if desired. Default is 255.255.255.0

Gateway

The Gateway IP address allows users to access the DSE-410D from outside the LAN.

MAC Address

The MAC address is fixed, not adjustable. It is assigned in the factory. Every Ethernet device manufactured has it own unique MAC address.

Link Status (Shown in Telnet or Console mode only)

Link status automatically displays the type of Ethernet connection. It will either display 10 BaseT or 100 BaseTX in full duplex or half duplex. This will depend on the LAN, switches, and hubs used in the LAN topology.

Server Serial Port (Select 1 or 2)

One port is shown. Make selections for Port 1 (Multi-Interface), then select Port 2 (RS-232) and make selections. Using the DSE-410D Manager, you must click Update to store settings for that port before changing to the other port. Only the settings for the port shown are stored. Using Telnet or Console mode, Save stores settings for both ports.

Baud Rate (Set for each port)

The serial port baud rate on the DSE-410D must match the serial baud rate of the connected device unless using Virtual COM mode. In Virtual COM mode, the software program will establish serial settings. Use the arrow keys to change the setting to the desired baud rate.

Data/Parity/Stop (Set for each port)

Set this to match the data format used by the device connected when the Virtual COM mode is not being used. Telnet/Console: Tab to the Data/Parity/Stop field and arrow to the desired selection.

Document Number: 940-0186-100 – DSE-410D Owner’s Manual

25

Quatech, Inc. - 5675 Hudson Industrial Parkway, Hudson, OH 44236 – 330.655.9000

http://www.quatech.com

Page 30 Page 32
Image 31
Page 30 Page 32
Contents World Headquarters Model DSE-410DPage Table of Contents Searching LAN for DSE-410D Server Name PasswordMAC Address Installing Virtual Com Port Page Introduction FeaturesVirtual COM Mode Direct IP ModeCommunication Modes Quick Start Heart Beat ConnectionDhcp Default DSE-410D SettingsSpecifications Optional Accessories DimensionsConfiguration Options Light Indication Side View when vertically mountedHardware Ethernet ConnectionTop View Power ConnectionReset Button Mode Switches DSE-410D Server PortDefault Setting RS-485 ModeRS-422 Mode RS-232 ModeSerial Connections RS-232 Connections RS-422 Connections RS-485 Connections Page Install Quatech DSE-410D Software Page Page Page Searching LAN for DSE-410D Using DSE-410D ManagerSearching Server Firmware UpgradeVirtual COM Configuration Uninstall Virtual COMServer Properties Screen ProtocolCOM Name StatusNext chapter Server Properties Configuration Server Name PasswordIP Address, Netmask, and Gateway Properties Baud Rate Set for each port Link Status Shown in Telnet or Console mode onlyMAC Address Server Serial Port Select 1 orTCP/UDP Port Set for each port Connection Mode Set for each portFlow Control Set for each port TCP/UDP Protocol Set for each portUpdate Page Installing Virtual Com Port Page Page Use Device Manager to View New Ports Page Page Removing a Virtual Com Port Removing the Virtual COM Port using Device Manager Page Page Using Virtual COM or Serial Connections Upgrade ModePage Page Page Console Mode Setup Page Appendix a RS-232, RS-422 Loopback Connections Page DB9M Appendix B RS-232 ConnectionsRS-232 Connections cont’d Appendix C RS-422 Connections Signal Name Direction PinRS-422 Connections cont’d Appendix D RS-485 Connections Page Appendix E Warranty Date of Purchase Model Number
Top Page Image Contents