Quatech DSE-410D manual Firmware Upgrade, Virtual COM Configuration, Searching Server, Server Name

Page 26

2.In the sidebar icon window select the icon labeled Searching Server. The Searching window is shown until all active DSE-410D Servers on the LAN are listed in the main DSE-410D Manager Window.

These items are shown in the sidebar icon window of the DSE-410D Manager:

Firmware Upgrade

This is used when downloading new firmware to the DSE-410D Server. See Chapter 8.

Virtual COM Configuration

Can be used to change the Virtual COM Settings, IP address, Port #, Flow Control.

Searching Server

Can be used to find DSE-410D Servers on the network.

Uninstall Virtual COM

Shown in Windows 2000 and XP Device Manager only. Uninstall utility for Windows 98 and Me is located in Start/Programs/Quatech/SDS/DSE-410D/ folder.

These items are shown in the right side DSE-410D Manager Window:

Server Name

The DSE-410D Servers are listed twice, once for each port.

IP Address

The IP address for both DSE-410D ports is the same for each port by design.

20	DSE-410D Owner’s Manual – Document Number: 940-0186-100

Quatech, Inc. - 5675 Hudson Industrial Parkway, Hudson, OH 44236 – 330.655.9000

http://www.quatech.com

Image 26

Contents Model DSE-410D World HeadquartersPage Table of Contents MAC Address Server Name PasswordSearching LAN for DSE-410D Installing Virtual Com Port Page Features IntroductionCommunication Modes Direct IP ModeVirtual COM Mode Heart Beat Connection Quick StartDefault DSE-410D Settings DhcpSpecifications Configuration Options DimensionsOptional Accessories Ethernet Connection Side View when vertically mountedHardware Light IndicationMode Switches DSE-410D Server Port Power ConnectionReset Button Top ViewRS-232 Mode RS-485 ModeRS-422 Mode Default SettingSerial Connections RS-232 Connections RS-422 Connections RS-485 Connections Page Install Quatech DSE-410D Software Page Page Page Using DSE-410D Manager Searching LAN for DSE-410DUninstall Virtual COM Firmware UpgradeVirtual COM Configuration Searching ServerStatus ProtocolCOM Name Server Properties ScreenNext chapter Server Properties Configuration IP Address, Netmask, and Gateway Properties PasswordServer Name Server Serial Port Select 1 or Link Status Shown in Telnet or Console mode onlyMAC Address Baud Rate Set for each portTCP/UDP Protocol Set for each port Connection Mode Set for each portFlow Control Set for each port TCP/UDP Port Set for each portUpdate Page Installing Virtual Com Port Page Page Use Device Manager to View New Ports Page Page Removing a Virtual Com Port Removing the Virtual COM Port using Device Manager Page Page Upgrade Mode Using Virtual COM or Serial ConnectionsPage Page Page Console Mode Setup Page Appendix a RS-232, RS-422 Loopback Connections Page Appendix B RS-232 Connections DB9MRS-232 Connections cont’d Signal Name Direction Pin Appendix C RS-422 ConnectionsRS-422 Connections cont’d Appendix D RS-485 Connections Page Appendix E Warranty Date of Purchase Model Number