Quatech DSE-410D manual

Page 2

Copyright

Copyright © 2003, Quatech, Inc. All rights are reserved. The

 

information contained in this document cannot be reproduced in any

 

form without the written consent of Quatech, Inc. Any software

 

programs that might accompany this document can be used only in

 

accordance with any license agreement(s) between the purchaser and

 

Quatech, Inc. Quatech, Inc. reserves the right to change this

 

documentation or the product to which it refers at any time and

 

without notice.

Trademarks

QUATECH® is a registered trademark of Quatech, Inc. Other

 

product and brand names listed in this manual may be trademarks of

 

their respective owners.

Disclaimer

The information in this manual is believed to be accurate and reliable

 

at the time of posting. Notwithstanding the foregoing, Quatech

 

assumes no responsibility for any damage or loss resulting from the

 

use of this manual, and expressly disclaims any liability or damages

 

for loss of data, loss of use, and property damage of any kind, direct,

 

incidental or consequential, in regard to or arising out of the

 

performance or form of the materials presented herein or in any

 

software program(s) that may accompany this document.

 

Changes or modifications to this device not explicitly approved by

 

Quatech will void the user's authority to operate this device.

Feedback

Quatech, Inc. encourages and appreciates feedback concerning this

 

document. Please send any written comments to the Technical

 

Support department at the address listed on the title page of this

 

manual.

Image 2
Contents Model DSE-410D World HeadquartersPage Table of Contents MAC Address Server Name PasswordSearching LAN for DSE-410D Installing Virtual Com Port Page Features IntroductionCommunication Modes Direct IP ModeVirtual COM Mode Heart Beat Connection Quick StartDefault DSE-410D Settings DhcpSpecifications Configuration Options DimensionsOptional Accessories Ethernet Connection Side View when vertically mountedHardware Light IndicationMode Switches DSE-410D Server Port Power ConnectionReset Button Top ViewRS-232 Mode RS-485 ModeRS-422 Mode Default SettingSerial Connections RS-232 Connections RS-422 Connections RS-485 Connections Page Install Quatech DSE-410D Software Page Page Page Using DSE-410D Manager Searching LAN for DSE-410DUninstall Virtual COM Firmware UpgradeVirtual COM Configuration Searching ServerStatus ProtocolCOM Name Server Properties ScreenNext chapter Server Properties Configuration IP Address, Netmask, and Gateway Properties PasswordServer Name Server Serial Port Select 1 or Link Status Shown in Telnet or Console mode onlyMAC Address Baud Rate Set for each portTCP/UDP Protocol Set for each port Connection Mode Set for each portFlow Control Set for each port TCP/UDP Port Set for each portUpdate Page Installing Virtual Com Port Page Page Use Device Manager to View New Ports Page Page Removing a Virtual Com Port Removing the Virtual COM Port using Device Manager Page Page Upgrade Mode Using Virtual COM or Serial ConnectionsPage Page Page Console Mode Setup Page Appendix a RS-232, RS-422 Loopback Connections Page Appendix B RS-232 Connections DB9MRS-232 Connections cont’d Signal Name Direction Pin Appendix C RS-422 ConnectionsRS-422 Connections cont’d Appendix D RS-485 Connections Page Appendix E Warranty Date of Purchase Model Number