Quatech DSE-410D manual Removing a Virtual Com Port

Page 41

7 Removing a Virtual Com Port

The DSE-410D Management software’s Uninstall Virtual COM port feature will remove the mapped COM port in the Device Manager of Windows 2000 and XP operating systems. It may also be removed in the Device Manager of Windows 98, Me, NT, 2000, and XP. Windows 98 users will also find a Remove Virtual COM feature in the programs file.

Removing the Virtual COM port with the DSE-410D Management software

1.At the Desk Top select Start/Programs/Quatech/ SDS/DSE-410D/DSE-410D Manager.

2.In the Manager window select Virtual COM Configuration. Highlight the mapped COM port number to be removed.

3.Select Uninstall Virtual COM button. The Manager will ask for confirmation. Select OK to complete the uninstall procedure.

Document Number: 940-0186-100 – DSE-410D Owner’s Manual

35

Quatech, Inc. - 5675 Hudson Industrial Parkway, Hudson, OH 44236 – 330.655.9000

http://www.quatech.com

Image 41

Contents World Headquarters Model DSE-410DPage Table of Contents MAC Address Server Name PasswordSearching LAN for DSE-410D Installing Virtual Com Port Page Introduction FeaturesCommunication Modes Direct IP ModeVirtual COM Mode Quick Start Heart Beat ConnectionDhcp Default DSE-410D SettingsSpecifications Configuration Options DimensionsOptional Accessories Hardware Side View when vertically mountedEthernet Connection Light IndicationReset Button Power ConnectionMode Switches DSE-410D Server Port Top ViewRS-422 Mode RS-485 ModeRS-232 Mode Default SettingSerial Connections RS-232 Connections RS-422 Connections RS-485 Connections Page Install Quatech DSE-410D Software Page Page Page Searching LAN for DSE-410D Using DSE-410D ManagerVirtual COM Configuration Firmware UpgradeUninstall Virtual COM Searching ServerCOM Name ProtocolStatus Server Properties ScreenNext chapter Server Properties Configuration IP Address, Netmask, and Gateway Properties PasswordServer Name MAC Address Link Status Shown in Telnet or Console mode onlyServer Serial Port Select 1 or Baud Rate Set for each portFlow Control Set for each port Connection Mode Set for each portTCP/UDP Protocol Set for each port TCP/UDP Port Set for each portUpdate Page Installing Virtual Com Port Page Page Use Device Manager to View New Ports Page Page Removing a Virtual Com Port Removing the Virtual COM Port using Device Manager Page Page Using Virtual COM or Serial Connections Upgrade ModePage Page Page Console Mode Setup Page Appendix a RS-232, RS-422 Loopback Connections Page DB9M Appendix B RS-232 ConnectionsRS-232 Connections cont’d Appendix C RS-422 Connections Signal Name Direction PinRS-422 Connections cont’d Appendix D RS-485 Connections Page Appendix E Warranty Date of Purchase Model Number