MTEK6000 SERIES USER'S MANUAL
It is disabled if set to 0. In this mode, the EFC should be configured to wake up on the number of pulses entered along with an hourly scheduled
Units of Measure
data. Therefore, the wake up interval (seconds) parameter should be set to 3600. The Default value is 0.
The MTEK6000 can be configured to calculate volume and flow with English or Metric units. The database ca be setup for the following units of measure:
Flow & Volume | ft3 (cubic feet) |
Accumulations | M3 (cubic meters) |
Static Pressure | PSI (pounds per square inch) |
| Kpa (Kilopascals) |
| Kg / cm2 (kilograms per square centimeter) |
| Bars |
| MBars (millibars) |
| Atmospheres |
| mmHg (millimeters of mercury) |
| mmH2O (millimeters of water) |
| MH2O (meters of water) |
| inH2O (inches of water) |
Temperature* | °F |
| °C |
Differential | inH2O (inches of water) |
Pressure | mmH2O (mm of water) |
Pipe & Orifice | inches |
Diameter | centimeters |
*The units for temperature are automatically set for °F or °C when the units for volume and flow are chosen. Choosing English units (cubic feet) will set the temperature to F, etc.
January 2002 | C - 7 |