Barco R9001560 manual Set up of the Baud Rate for Communication with a Computer

Connections

Connecting a Computer, e.g. IBM PC (or compatible), Apple Macintosh to the RS 232 input of the projector.

The projector has a RS232 port that allows it to communicate with a computer.

Applications : remote control and data communications.

a)remote control :

-easy adjustment of projector via IBM PC (or compat- ible) or MAC connection.

-allow storage of multiple projector configurations and set ups.

-wide range of control possibilities.

-address range from 0 to 255.

b)data communications :

-sending data to the projector or copying the data from the projector to a hard memory device.

Set up of the Baud Rate for Communication with a Computer.

See 'Change Baudrate PC' in chapter 'Service mode'.

Connecting a RCVDS 05 to the projector.

-Up to 20 inputs with the RCVDS 05 and 90 inputs when RCVDS's are linked via the expansion module.

-Serial communication with the projector.

-Remote control buttons on the RCVDS to control the projector (source selection and analog settings).

-The selected source number will be displayed on a 2 digit display and the selected input module will be indicated with a LED on the rear.

For more information about the use of : the RCVDS 05, consult the

owner's manual, order number : R5975765.

Connecting a VS05 to the projector

The VS05 can switch up to 5 Composite Video sources, 3 Super Video sources and 1 RGB analog or component video source to the projector. In addition, the audio signal proper to the source, can be switched to an audio amplifier.

Order number : R9827890

For more information about the use of the VS05, consult the VS05 owner's manual, BARCO order number : R5975245.

			PROJECTOR MODE :
			GREEN - OPERATION	DIAGNOSTICS
RS232 OUT	RS 232IN	COMMUNICATION PORT	RED - STANDBY	IR-ACKNOWLEDGED CODE	IR-RECEIVER
		(800-PERIPHERALS)	REMOTE			SDI IN	SDI OUT	XLR

IR-RECEIVED

R

G

B 56FRQQHFWLRQ￿￿￿VG

B

H / C

V

6￿9,'(29,'(9,'(2￿,1387

R

G

B

H / C

V

9827910

On

Connecting an IR Remote Receiver 800 to the projector.

This infrared receiver unit makes it possible to control the projector
from another room.
There is a communication line cable between the IR receiver and the
projector or the RCVDS. The control information from the RCU can	Screen
now be sent to the IR Remote Receiver 800.
The IR Remote Receiver 800 displays the selected source on a 7-
segment display.
Order number : R9827515.

Communication cable

IR Remote Receiver 800

Projector

Projection room Control room

5-10 5976052 BARCOREALITY 9300 070999