Lenses
BLENSES
Focusing the lens
Loosen the fastener ring of the lens by turning counter clockwise.
Focus the image by turning the lens barrel to the left or the right. Attention : Do not turn out the lens too far, otherwise it will fall out of the lens holder.
When the image is focused, secure the correct position of the lens with the fastener ring by turning this ring clockwise.
Lens
holder Fastener ring
Lens
Lens Cleaning Procedure
Cleaning procedure for HD(1.5-3:1) lens.
To minimize the possibility of damaging the optical coating or scratch- ing exposed lens surface, we have developed recommendations for cleaning the lens. FIRST, we recommend you try to remove any material from the lens by blowing it off with clean, dry deionized air. DO NOT use any liquid to clean the lenses.
A TorayseeTM cloth is included with the lens kit.
Proceed as follows :
1.Always wipe lenses with a CLEAN TorayseeTM cloth.
2.Always wipe lenses in a single direction. Do not wipe back and forwards across the lens surface as this tends to grind dirt into the coating.
3.Do not leave cleaning cloth in either an open room or lab coat pocket, as doing so can contaminate the cloth.
4.If smears occur when cleaning lenses, replace the cloth. Smears are the first indication of a dirty cloth.
5.Do not use fabric softener when washing the cleaning cloth or softener sheets when drying the cloth.
6.Do not use liquid cleaners on the cloth as doing so will contaminate the cloth.
Order number for a new TorayseeTM cloth : R379058.
Other lenses can also be cleaned safely with this TorayseeTM cloth. Cleaning procedure for the other HD lens
To minimize the possibility of damaging the optical coating or scratch-
ing exposed lens surfaces, we have developed recommendations for cleaning lenses. FIRST, we recommend you try to remove any material from the lens by blowing it off with deionized air or lightly brushing it with a soft, camel's hair brush.
Plastic lens with multilayer coatings & all glass lens elements.
1.DO NOT spray any type of fluid directly on the lens surface.
2.DO NOT use any dry material to clean the surface (dry rag, tissue, etc.)
3.Use a commercial liquid window cleaner. DO NOT use an aerosol. Other cleaning agents, such as
4.Use a soft cotton cloth (cotton diapers laundered several times to remove sizing) or any soft facial tissue (Charmin, Softweve, etc.).
5.When using window cleaner, moisten the cloth or tissue and lightly wipe the surface. Then lightly dry with a new tissue.
6.When using acetone or ethyl ether mixture, proceed as follows : Fold the cloth or tissue several times to form a pad. Soak the folded end of the pad in the acetone. Starting at the diameter opposite you, immediately wipe the coated lens, with very little pressure, toward you in a straight line and off the lens. Do not stop with the tissue on the lens. Wipe at a speed that is equal to the evaporation rate. This is very important to prevent streaking and spotting. Start your wiping at one side of the lens and, with successive wipes, move to the other side. Turn the pad over for each wipe, then inside out. Do not make more than one wipe per clean area of pad. Be careful of the painted edge, since acetone will soften it.
5976052 BARCOREALITY 9300 070999 |
| |
|