Barco R9001560 manual Rcu, Projector Address

Controlling

c) RCU used in a hardwired configuration with XLR connector.

Plug one end of the remote cable in the connector on the bottom of the RCU and the second side in the connector in the front panel of the projector labelled 'CTRL2'.

d)Point the front of the RCU directly at one of the IR sensors of the projector.

When using the wireless remote control, make sure you are within the effective operating distance (30m, 100ft in a straight line). The remote control unit will not function properly if strong light strikes the sensor window or if there are obstacles between the remote control unit and the projector IR sensor.

0 I

PROJECTOR MODE :

GREEN - OPERATION DIAGNOSTICS SDI IN SDI OUT XLR

	RS 232IN	COMMUNICATION PORT	RED - STANDBY	IR-ACKNOWLEDGED	CODE	IR-RECEIVER
RS 232 OUT		(800-PERIPHERALS)	REMOTE

IR-RECEIVED

R

G

B

H

V

R

G

B

H / C

V

R

G

B

H / C

V

On

9827910

RCU

IR sensor IR sensor

0 I

Table Rear of projector

Front of projector

45° 45° 45° 45°

RCU

RCU

Projector Address

a. Software Set up of the Projector Address.

See 'Change projector address' in chapter 'Service mode'.

b. How to Control the Projector or Projectors.

Every projector requires an individual address between 0 and 255 which can be set in the Service mode. When the address is set, the projector can be controlled now :

-RCU for addresses between 0 and 9.

-Computer, e.g. IBM PC (or compatible), Apple MAC, etc. for addresses between 0 and 255.

Note : A projector will respond to a RCU set to an address of '0' regardless of what address is set in the projector itself.

c. Using the RCU.

Before using the RCU, its is necessary to enter the projector address into the RCU (only when that address is between 0 and 9). The projector with the corresponding address will listen to that specific RCU.

When address 0, <zero> is programmed into the RCU, every projector, without exception will listen to the commands given by this RCU.

6-2 5976052 BARCOREALITY 9300 070999