InFocus IN12 manual

Contents Page Contents Enter About this manualFocus S, Focus T To adjust image brightness Adjusting Image BrightnessOperation During Projection Image Operations During ProjectionTo change the color mode Selecting the Color ModeZooming an Image Freezing an Image Momentarily Cutting Off the Input Source ImageTo freeze the projected image Press the Blank keyTo display a pointer in the image Displaying a Pointer in the Projected ImageTo select the pointer type To clear the pointer from the imageTo turn the Eco Mode on or off Eco ModeChanging the aspect ratio of the projected image Adjust image brightness Using the Func KeyTurn the Eco Mode on or off Basic Setup Menu Operations Configuring Advanced Projector SettingsDisplaying the Setup Menu Configuring Setup Menu SettingsTo configure the Image Adjustment J Contrast setting Basic Setup Menu ExampleTo configure the Image Adjustment J Color Mode setting To configure the Option Settings 1 J Eco Mode setting Page Setup Menu Contents Image Adjustment Main Menu Normal RCVStill Image About the Signal Specific Setting Unit Screen Settings Main MenuRcvun 169None LogoBlue BlackBlank Screen Auto Input Settings Main MenuComponent Ntsc / NTSC4.43 / PAL / PAL-M / PAL-N / PAL60Option Settings 1 Main Menu Setting Name Description Input Unit Arrow 1* / Arrow 2 / Bar 1 / Bar 2 / Oval 1 / Oval Option Settings 2 Main MenuSpot 1 / Spot Operational Info Main Menu RCV N Restore All Defaults Main MenuCleaning the Projector User MaintenanceCleaning the Projector Exterior Cleaning the LensTo check the current lamp use time Replacing the LampReplacing the Lamp When to replace the lampLoosen the three screws indicated by an S mark To replace the lampResetting the Lamp Time To reset the lamp time after exceeding the lamp life To reset the lamp timeAppendix Remote Controller Signal RangeConnecting to a Component Video Output Device Full-screen Display of an RGB Image Input Signal Example Projected ImageReattaching the Lens Cover