InFocus IN12 manual Connecting to a Component Video Output Device

Page 33

Connecting to a Component Video Output Device

Some video devices are equipped with a component video output terminal. You can use an optionally available VESA to component video adapter (SP-VESA-ADPT-R)and a component video cable to connect the RGB input terminal of the projector to the component video output terminal of a video device.

Important!

Always turn off the projector and the video device before connecting them.

zComponent video output terminals come in 3-terminal sets: Y·Cb·Cr or Y·Pb·Pr. Be sure to match the colors of the plugs on the optional adapter with the colors of the terminals (Green: Y; Blue: Cb/Pb; Red: Cr/Pr).

zNote that connection only to an analog component video output terminal is supported. Connection to a digital output terminal is not supported.

32

Image 33

Contents Page Contents About this manual EnterFocus S, Focus T To adjust image brightness Adjusting Image BrightnessOperation During Projection Image Operations During ProjectionSelecting the Color Mode To change the color modeZooming an Image Freezing an Image Momentarily Cutting Off the Input Source ImageTo freeze the projected image Press the Blank keyTo display a pointer in the image Displaying a Pointer in the Projected ImageTo select the pointer type To clear the pointer from the imageEco Mode To turn the Eco Mode on or offChanging the aspect ratio of the projected image Using the Func Key Adjust image brightnessTurn the Eco Mode on or off Basic Setup Menu Operations Configuring Advanced Projector SettingsDisplaying the Setup Menu Configuring Setup Menu SettingsBasic Setup Menu Example To configure the Image Adjustment J Contrast settingTo configure the Image Adjustment J Color Mode setting To configure the Option Settings 1 J Eco Mode setting Page Setup Menu Contents Image Adjustment Main Menu RCV NormalStill Image About the Signal Specific Setting Unit Screen Settings Main MenuRcvun 169None LogoBlue BlackBlank Screen Auto Input Settings Main MenuComponent Ntsc / NTSC4.43 / PAL / PAL-M / PAL-N / PAL60Option Settings 1 Main Menu Setting Name Description Input Unit Option Settings 2 Main Menu Arrow 1* / Arrow 2 / Bar 1 / Bar 2 / Oval 1 / OvalSpot 1 / Spot Operational Info Main Menu RCV N Restore All Defaults Main MenuCleaning the Projector User MaintenanceCleaning the Projector Exterior Cleaning the LensTo check the current lamp use time Replacing the LampReplacing the Lamp When to replace the lampLoosen the three screws indicated by an S mark To replace the lampResetting the Lamp Time To reset the lamp time after exceeding the lamp life To reset the lamp timeAppendix Remote Controller Signal RangeConnecting to a Component Video Output Device Full-screen Display of an RGB Image Input Signal Example Projected ImageReattaching the Lens Cover